From mboxrd@z Thu Jan 1 00:00:00 1970 From: martin.blumenstingl@googlemail.com (Martin Blumenstingl) Date: Sun, 22 Jan 2017 19:10:23 +0100 Subject: [PATCH v4 4/9] ARM64: dts: meson-gxbb-nexbox-a95x: add the ethernet PHY's reset GPIO In-Reply-To: <20170122181028.5014-1-martin.blumenstingl@googlemail.com> References: <20170120152232.13943-1-martin.blumenstingl@googlemail.com> <20170122181028.5014-1-martin.blumenstingl@googlemail.com> Message-ID: <20170122181028.5014-5-martin.blumenstingl@googlemail.com> To: linus-amlogic@lists.infradead.org List-Id: linus-amlogic.lists.infradead.org This resets the ethernet PHY during boot to get the PHY into a "clean" state. While here also specify the phy-handle of the ethmac node to make the PHY configuration similar to the one we have on GXL devices. This will allow us to specify OF-properties for the PHY itself. Signed-off-by: Martin Blumenstingl Tested-by: Neil Armstrong --- arch/arm64/boot/dts/amlogic/meson-gxbb-nexbox-a95x.dts | 16 ++++++++++++++++ 1 file changed, 16 insertions(+) diff --git a/arch/arm64/boot/dts/amlogic/meson-gxbb-nexbox-a95x.dts b/arch/arm64/boot/dts/amlogic/meson-gxbb-nexbox-a95x.dts index e642bfd5eec5..cdd2f3107432 100644 --- a/arch/arm64/boot/dts/amlogic/meson-gxbb-nexbox-a95x.dts +++ b/arch/arm64/boot/dts/amlogic/meson-gxbb-nexbox-a95x.dts @@ -164,7 +164,23 @@ status = "okay"; pinctrl-0 = <ð_rmii_pins>; pinctrl-names = "default"; + phy-handle = <ð_phy0>; phy-mode = "rmii"; + + snps,reset-gpio = <&gpio GPIOZ_14 0>; + snps,reset-delays-us = <0 10000 1000000>; + snps,reset-active-low; + + mdio { + compatible = "snps,dwmac-mdio"; + #address-cells = <1>; + #size-cells = <0>; + + eth_phy0: ethernet-phy at 0 { + /* IC Plus IP101GR (0x02430c54) */ + reg = <0>; + }; + }; }; &ir { -- 2.11.0