[PATCH RESEND v2 0/2] pinctrl-meson: two small improvements

From: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
To: linus.walleij@linaro.org, linux-gpio@vger.kernel.org,
	linux-amlogic@lists.infradead.org
Cc: Martin Blumenstingl <martin.blumenstingl@googlemail.com>,
	khilman@baylibre.com, linux-kernel@vger.kernel.org,
	linux-arm-kernel@lists.infradead.org, jbrunet@baylibre.com
Subject: [PATCH RESEND v2 0/2] pinctrl-meson: two small improvements
Date: Fri, 17 Apr 2020 20:33:47 +0200	[thread overview]
Message-ID: <20200417183349.1283092-1-martin.blumenstingl@googlemail.com> (raw)

While playing with audio output on Meson8b I found out that the
vendor kernel uses a custom version of the GPIO_PULL_UP flag. I
suspect that we will need this for audio support on Meson8b and/or
Meson8m2 but I don't see it hurt other platforms.

Also while comparing the register bits with the GPIO direction (of
GPIOs exported to sysfs) I sometimes had a mismatch. This also wires
up gpio_chip.get_direction to have sysfs and the actual registers in
sync.

Changes since v1 from [0]:
- re-send as non-"RFC" because I only got one comment in the past week
  for patch #2. Jerome pointed out an alternative way to GPIO_PULL_UP
  and GPIO_PULL_DOWN. However, this doesn't invalidate the patch, it
  just means that there are two ways to achieve the same goal.

[0] https://patchwork.kernel.org/cover/11484185/

Martin Blumenstingl (2):
  pinctrl: meson: implement the gpio_chip get_direction callback
  pinctrl: meson: wire up the gpio_chip's set_config callback

 drivers/pinctrl/meson/pinctrl-meson.c | 14 ++++++++++++++
 1 file changed, 14 insertions(+)

-- 
2.26.1

_______________________________________________
linux-amlogic mailing list
linux-amlogic@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-amlogic