mirror of https://lore.kernel.org/linux-amlogic/
 help / color / mirror / Atom feed
From: Andrew Lunn <andrew@lunn.ch>
To: Lucas Tanure <tanure@linux.com>
Cc: xianwei.zhao@amlogic.com, Andrew Lunn <andrew+netdev@lunn.ch>,
	"David S. Miller" <davem@davemloft.net>,
	Eric Dumazet <edumazet@kernel.org>,
	Jakub Kicinski <kuba@kernel.org>, Paolo Abeni <pabeni@redhat.com>,
	Rob Herring <robh@kernel.org>,
	Krzysztof Kozlowski <krzk+dt@kernel.org>,
	Conor Dooley <conor+dt@kernel.org>,
	Neil Armstrong <neil.armstrong@linaro.org>,
	Kevin Hilman <khilman@baylibre.com>,
	Jerome Brunet <jbrunet@baylibre.com>,
	Martin Blumenstingl <martin.blumenstingl@googlemail.com>,
	Maxime Chevallier <maxime.chevallier@bootlin.com>,
	Maxime Coquelin <mcoquelin.stm32@gmail.com>,
	Alexandre Torgue <alexandre.torgue@foss.st.com>,
	netdev@vger.kernel.org, devicetree@vger.kernel.org,
	linux-arm-kernel@lists.infradead.org,
	linux-amlogic@lists.infradead.org, linux-kernel@vger.kernel.org
Subject: Re: [RFC PATCH v2 0/7] Add ethernet support for the Amlogic T7
Date: Fri, 9 Oct 2026 14:13:24 +0200	[thread overview]
Message-ID: <3a037c87-e4c5-4a4e-9522-cf505e1c6399@lunn.ch> (raw)
In-Reply-To: <CAJX_Q+2au4x99kj=UBqn4joQCM3-D2kbaJ0zro9Y4RXka7ePvQ@mail.gmail.com>

On Fri, Oct 09, 2026 at 06:59:49AM +0100, Lucas Tanure wrote:
> On Wed, Oct 7, 2026 at 2:01 PM Andrew Lunn <andrew@lunn.ch> wrote:
> >
> > On Wed, Oct 07, 2026 at 09:26:20AM +0100, Lucas Tanure wrote:
> > > The T7 pairs a Synopsys gigabit MAC with the same glue registers the
> > > G12A has, but nothing described it. This adds the binding, the driver
> > > support and the device tree nodes, and enables the port on the Khadas
> > > VIM4.
> > >
> > > Unlike the G12A, the controller reaches DRAM through a pipeline stage
> > > with a gate of its own, sys_ampipe_eth. Nothing else claims it, so
> > > clk_disable_unused switches it off and transfers stop.
> > >
> > > v2 changes the RGMII delays, after review. phy-mode describes the
> > > board, not which chip adds the delay, so this board is rgmii-id.
> > > dwmac-meson8b did the opposite, and ignored the *-internal-delay-ps
> > > properties. Patch 1 fixes that. The VIM4 needs it because the RTL8211F
> > > transmit delay does not work here.
> >
> > What is special about the RTL8211F?
> Maybe nothing, it may be this board. I cannot tell from here.

Yes, look at my other reply. The RTL8211F is very likely correct. It
is the MAC drivers handling of delays which is broken. You get to fix
it for this new device.

   Andrew

_______________________________________________
linux-amlogic mailing list
linux-amlogic@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-amlogic

  reply	other threads:[~2026-10-09 12:13 UTC|newest]

Thread overview: 25+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2026-10-07  8:26 Lucas Tanure
2026-10-07  8:26 ` [RFC PATCH v2 1/7] net: stmmac: dwmac-meson8b: let the controller apply the RGMII delays Lucas Tanure
2026-10-07  9:35   ` Maxime Chevallier
2026-10-07 12:58   ` Andrew Lunn
2026-10-07  8:26 ` [RFC PATCH v2 2/7] dt-bindings: net: amlogic,meson-dwmac: list the compatible combinations Lucas Tanure
2026-10-07  8:26 ` [RFC PATCH v2 3/7] dt-bindings: net: amlogic,meson-dwmac: add amlogic,t7-dwmac Lucas Tanure
2026-10-07  9:51   ` Conor Dooley
2026-10-07 10:34     ` Lucas Tanure
2026-10-07 12:59       ` Conor Dooley
2026-10-07 12:35   ` Neil Armstrong
2026-10-07 13:07     ` Andrew Lunn
2026-10-07 13:06   ` Andrew Lunn
2026-10-08  8:26   ` sashiko-bot
2026-10-07  8:26 ` [RFC PATCH v2 4/7] net: stmmac: dwmac-meson8b: add support for the Amlogic T7 Lucas Tanure
2026-10-07  8:26 ` [RFC PATCH v2 5/7] arm64: dts: amlogic: t7: add the ethernet pinctrl nodes Lucas Tanure
2026-10-07  8:26 ` [RFC PATCH v2 6/7] arm64: dts: amlogic: t7: add the ethernet controller Lucas Tanure
2026-10-07 13:12   ` Andrew Lunn
2026-10-07 13:34     ` Maxime Chevallier
2026-10-09  5:52     ` Lucas Tanure
2026-10-07  8:26 ` [RFC PATCH v2 7/7] arm64: dts: amlogic: t7: khadas-vim4: enable the ethernet port Lucas Tanure
2026-10-08  8:26   ` sashiko-bot
2026-10-07 13:01 ` [RFC PATCH v2 0/7] Add ethernet support for the Amlogic T7 Andrew Lunn
2026-10-09  5:59   ` Lucas Tanure
2026-10-09 12:13     ` Andrew Lunn [this message]
2026-10-09 20:52       ` Lucas Tanure

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=3a037c87-e4c5-4a4e-9522-cf505e1c6399@lunn.ch \
    --to=andrew@lunn.ch \
    --cc=alexandre.torgue@foss.st.com \
    --cc=andrew+netdev@lunn.ch \
    --cc=conor+dt@kernel.org \
    --cc=davem@davemloft.net \
    --cc=devicetree@vger.kernel.org \
    --cc=edumazet@kernel.org \
    --cc=jbrunet@baylibre.com \
    --cc=khilman@baylibre.com \
    --cc=krzk+dt@kernel.org \
    --cc=kuba@kernel.org \
    --cc=linux-amlogic@lists.infradead.org \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=martin.blumenstingl@googlemail.com \
    --cc=maxime.chevallier@bootlin.com \
    --cc=mcoquelin.stm32@gmail.com \
    --cc=neil.armstrong@linaro.org \
    --cc=netdev@vger.kernel.org \
    --cc=pabeni@redhat.com \
    --cc=robh@kernel.org \
    --cc=tanure@linux.com \
    --cc=xianwei.zhao@amlogic.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox

all inboxes | Powered by JetHome®