Re: [PATCH V6 3/5] tty: serial: meson: Describes the calculation of the UART baud rate clock using a clock frame

[Yu Tu <yu.tu@amlogic.com>]

On 2022/1/21 5:48, Jerome Brunet wrote:
> [ EXTERNAL EMAIL ]
> 
> 
> On Tue 18 Jan 2022 at 10:39, Jiri Slaby <jirislaby@kernel.org> wrote:
> 
>> On 18. 01. 22, 4:09, Yu Tu wrote:
>>> Using the common Clock code to describe the UART baud rate clock
>>> makes it easier for the UART driver to be compatible with the
>>> baud rate requirements of the UART IP on different meson chips.
>> ...
>>> --- a/drivers/tty/serial/meson_uart.c
>>> +++ b/drivers/tty/serial/meson_uart.c
>> ...
>>> @@ -629,57 +640,105 @@ static struct uart_driver meson_uart_driver = {
>>>    	.cons		= MESON_SERIAL_CONSOLE,
>>>    };
>>>    -static inline struct clk *meson_uart_probe_clock(struct device *dev,
>>> -						 const char *id)
>>> -{
>>> -	struct clk *clk = NULL;
>>> -	int ret;
>>> -
>>> -	clk = devm_clk_get(dev, id);
>>> -	if (IS_ERR(clk))
>>> -		return clk;
>>> -
>>> -	ret = clk_prepare_enable(clk);
>>> -	if (ret) {
>>> -		dev_err(dev, "couldn't enable clk\n");
>>> -		return ERR_PTR(ret);
>>> -	}
>>> -
>>> -	devm_add_action_or_reset(dev,
>>> -			(void(*)(void *))clk_disable_unprepare,
>>> -			clk);
>>> -
>>> -	return clk;
>>> -}
>>> +static struct clk_div_table xtal_div_table[] = {
>>
>> This can be const, right?
>>
>>> +	{0, 3},
>>> +	{1, 1},
>>> +	{2, 2},
>>> +	{3, 2},
>>
>> Not sure if you didn't remove too much whitespace. I think it should be
>> like: "{ 0, 3 },". But I actually don't care, it's a minor thing.
> 
> Seconds
> It worth fixing in the next version
> 
I will correct in a version.
>>
>> I cannot comment on the rest (clk and OF part) as my knowledge is pretty
>> limited there. Leaving up to others.
>>
>> thanks,
> 

_______________________________________________
linux-amlogic mailing list
linux-amlogic@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-amlogic