From mboxrd@z Thu Jan 1 00:00:00 1970 From: martin.blumenstingl@googlemail.com (Martin Blumenstingl) Date: Mon, 14 May 2018 22:55:40 +0200 Subject: [PATCH v2 0/4] Meson8m2 (32-bit ARM) SoC support In-Reply-To: <7h603v115k.fsf@baylibre.com> References: <20180509235037.5876-1-martin.blumenstingl@googlemail.com> <7h603v115k.fsf@baylibre.com> Message-ID: To: linus-amlogic@lists.infradead.org List-Id: linus-amlogic.lists.infradead.org On Fri, May 11, 2018 at 2:33 AM, Kevin Hilman wrote: > Martin Blumenstingl writes: > >> This series adds support for the Meson8m2 SoC. This SoC is mostly >> compatible with Meson8 while using some peripherals from Meson8b. Patch >> #4 contains a list of (known) differences between the Meson8 and Meson8m2 >> SoCs. >> >> The first supported board with Meson8m2 SoC is the "Tronsmart MXIII Plus" >> where Oleg contributed the initial .dts and heavily tested it (many >> thanks!). His testing also confirmed that the Meson8m2 SoC uses the same >> register layout for the Ethernet "glue registers (supported by the >> dwmac-meson8b driver) as Meson8b. >> >> changes since v1 at [0]: >> - do not create a new MACH_MESON8M2 Kconfig entry as suggested by Kevin >> (MACH_MESON8 is re-used instead). This affects patch #1 (which was >> patch #3 in v1) and patch #4 (which was patch #6 in v1) >> - dropped patches #1 and #2 from v1 because Kevin already applied these >> ("dt-bindings: arm: amlogic: add support for the Meson8m2 SoC" and >> "dt-bindings: arm: amlogic: add support for the Tronsmart MXIII Plus") > > Applied to v4.18/dt. thank you! > One more request: Could you send one more patch (on top of my v4.18/dt) > that gets rid of the Kconfig for the 8B also? I put that on my TODO-list, I'll send a patch before my next batch of 32-bit dt updates Regards Martin