From mboxrd@z Thu Jan 1 00:00:00 1970 From: f.fainelli@gmail.com (Florian Fainelli) Date: Sat, 26 Nov 2016 21:55:37 -0800 Subject: [PATCH 2/2] net: phy: realtek: fix enabling of the TX-delay for RTL8211F In-Reply-To: <20161125131201.19994-3-martin.blumenstingl@googlemail.com> References: <20161125131201.19994-1-martin.blumenstingl@googlemail.com> <20161125131201.19994-3-martin.blumenstingl@googlemail.com> Message-ID: To: linus-amlogic@lists.infradead.org List-Id: linus-amlogic.lists.infradead.org On 11/25/2016 05:12 AM, Martin Blumenstingl wrote: > The old logic always enabled the TX-delay when the phy-mode was set to > PHY_INTERFACE_MODE_RGMII. There are dedicated phy-modes which tell the > PHY driver to enable the RX and/or TX delays: > - PHY_INTERFACE_MODE_RGMII should disable the RX and TX delay in the > PHY (if required, the MAC should add the delays in this case) > - PHY_INTERFACE_MODE_RGMII_ID should enable RX and TX delay in the PHY > - PHY_INTERFACE_MODE_RGMII_TXID should enable the TX delay in the PHY > - PHY_INTERFACE_MODE_RGMII_RXID should enable the RX delay in the PHY > (currently not supported by RTL8211F) > > With this patch we enable the TX delay for PHY_INTERFACE_MODE_RGMII_ID > and PHY_INTERFACE_MODE_RGMII_TXID. > Additionally we now explicity disable the TX-delay, which seems to be > enabled automatically after a hard-reset of the PHY (by triggering it's > reset pin) to get a consistent state (as defined by the phy-mode). > > This fixes a compatibility problem with some SoCs where the TX-delay was > also added by the MAC. With the TX-delay being applied twice the TX > clock was off and TX traffic was broken or very slow (<10Mbit/s) on > 1000Mbit/s links. > > Signed-off-by: Martin Blumenstingl Reviewed-by: Florian Fainelli -- Florian