Re: [PATCH v6 09/10] scsi: ufs: ufs-qcom: Check return value of phy_set_mode_ext()

[Can Guo <quic_cang@quicinc.com>]

On 11/30/2023 3:16 PM, Manivannan Sadhasivam wrote:
> On Wed, Nov 29, 2023 at 12:28:34AM -0800, Can Guo wrote:
>> In ufs_qcom_power_up_sequence(), check return value of phy_set_mode_ext()
>> and stop proceeding if phy_set_mode_ext() fails.
>>
>> Signed-off-by: Can Guo <quic_cang@quicinc.com>
>> ---
>>   drivers/ufs/host/ufs-qcom.c | 7 ++++++-
>>   1 file changed, 6 insertions(+), 1 deletion(-)
>>
>> diff --git a/drivers/ufs/host/ufs-qcom.c b/drivers/ufs/host/ufs-qcom.c
>> index 30f4ca6..9c0ebbc 100644
>> --- a/drivers/ufs/host/ufs-qcom.c
>> +++ b/drivers/ufs/host/ufs-qcom.c
>> @@ -475,7 +475,12 @@ static int ufs_qcom_power_up_sequence(struct ufs_hba *hba)
>>   		return ret;
>>   	}
>>   
>> -	phy_set_mode_ext(phy, mode, host->phy_gear);
>> +	ret = phy_set_mode_ext(phy, mode, host->phy_gear);
>> +	if (ret) {
>> +		dev_err(hba->dev, "%s: phy set mode failed, ret = %d\n",
>> +			__func__, ret);
> 
> No need to print the error message here as it is already done in the PHY driver.
> 
> Also, this patch should come before the PHY patch returning error.

Sure.

Thanks,
Can Guo.

> 
> - Mani
> 
>> +		goto out_disable_phy;
>> +	}
>>   
>>   	/* power on phy - start serdes and phy's power and clocks */
>>   	ret = phy_power_on(phy);
>> -- 
>> 2.7.4
>>
>>
>