[PATCH 01/14] staging: rtl8723bs: Remove unused structs starting with profile_info

[Philipp Hortmann <philipp.g.hortmann@gmail.com>]

Remove unused structs.

Signed-off-by: Philipp Hortmann <philipp.g.hortmann@gmail.com>
---
 drivers/staging/rtl8723bs/include/rtw_mlme.h | 133 -------------------
 1 file changed, 133 deletions(-)

diff --git a/drivers/staging/rtl8723bs/include/rtw_mlme.h b/drivers/staging/rtl8723bs/include/rtw_mlme.h
index fc0b43d38d9a..7ce8eaf4ec80 100644
--- a/drivers/staging/rtl8723bs/include/rtw_mlme.h
+++ b/drivers/staging/rtl8723bs/include/rtw_mlme.h
@@ -141,139 +141,6 @@ struct rt_link_detect_t {
 	u32 LowPowerTransitionCount;
 };
 
-struct profile_info {
-	u8 ssidlen;
-	u8 ssid[WLAN_SSID_MAXLEN];
-	u8 peermac[ETH_ALEN];
-};
-
-struct tx_invite_req_info {
-	u8 			token;
-	u8 			benable;
-	u8			go_ssid[WLAN_SSID_MAXLEN];
-	u8 			ssidlen;
-	u8			go_bssid[ETH_ALEN];
-	u8			peer_macaddr[ETH_ALEN];
-	u8 			operating_ch;	/* 	This information will be set by using the p2p_set op_ch =x */
-	u8 			peer_ch;		/* 	The listen channel for peer P2P device */
-
-};
-
-struct tx_invite_resp_info {
-	u8 			token;	/* 	Used to record the dialog token of p2p invitation request frame. */
-};
-
-struct tx_provdisc_req_info {
-	u16 				wps_config_method_request;	/* 	Used when sending the provisioning request frame */
-	u16 				peer_channel_num[2];		/* 	The channel number which the receiver stands. */
-	struct ndis_802_11_ssid	ssid;
-	u8			peerDevAddr[ETH_ALEN];		/*	Peer device address */
-	u8			peerIFAddr[ETH_ALEN];		/*	Peer interface address */
-	u8 			benable;					/* 	This provision discovery request frame is trigger to send or not */
-};
-
-struct rx_provdisc_req_info {	/* When peer device issue prov_disc_req first, we should store the following information */
-	u8			peerDevAddr[ETH_ALEN];		/*	Peer device address */
-	u8 			strconfig_method_desc_of_prov_disc_req[4];	/* 	description for the config method located in the provisioning discovery request frame. */
-																	/* 	The UI must know this information to know which config method the remote p2p device is requiring. */
-};
-
-struct tx_nego_req_info {
-	u16 				peer_channel_num[2];		/* 	The channel number which the receiver stands. */
-	u8			peerDevAddr[ETH_ALEN];		/*	Peer device address */
-	u8 			benable;					/* 	This negotiation request frame is trigger to send or not */
-};
-
-struct group_id_info {
-	u8			go_device_addr[ETH_ALEN];	/*	The GO's device address of this P2P group */
-	u8			ssid[WLAN_SSID_MAXLEN];	/*	The SSID of this P2P group */
-};
-
-struct scan_limit_info {
-	u8 			scan_op_ch_only;			/* 	When this flag is set, the driver should just scan the operation channel */
-	u8 			operation_ch[2];				/* 	Store the operation channel of invitation request frame */
-};
-
-struct wifidirect_info {
-	struct adapter				*padapter;
-	struct timer_list					find_phase_timer;
-	struct timer_list					restore_p2p_state_timer;
-
-	/* 	Used to do the scanning. After confirming the peer is availalble, the driver transmits the P2P frame to peer. */
-	struct timer_list					pre_tx_scan_timer;
-	struct timer_list					reset_ch_sitesurvey;
-	struct timer_list					reset_ch_sitesurvey2;	/* 	Just for resetting the scan limit function by using p2p nego */
-	struct tx_provdisc_req_info tx_prov_disc_info;
-	struct rx_provdisc_req_info rx_prov_disc_info;
-	struct tx_invite_req_info invitereq_info;
-	struct profile_info		profileinfo[P2P_MAX_PERSISTENT_GROUP_NUM];	/*	Store the profile information of persistent group */
-	struct tx_invite_resp_info inviteresp_info;
-	struct tx_nego_req_info nego_req_info;
-	struct group_id_info 	groupid_info;	/* 	Store the group id information when doing the group negotiation handshake. */
-	struct scan_limit_info 	rx_invitereq_info;	/* 	Used for get the limit scan channel from the Invitation procedure */
-	struct scan_limit_info 	p2p_info;		/* 	Used for get the limit scan channel from the P2P negotiation handshake */
-	enum p2p_role			role;
-	enum p2p_state			pre_p2p_state;
-	enum p2p_state			p2p_state;
-	u8 				device_addr[ETH_ALEN];	/* 	The device address should be the mac address of this device. */
-	u8 				interface_addr[ETH_ALEN];
-	u8 				social_chan[4];
-	u8 				listen_channel;
-	u8 				operating_channel;
-	u8 				listen_dwell;		/* 	This value should be between 1 and 3 */
-	u8 				support_rate[8];
-	u8 				p2p_wildcard_ssid[P2P_WILDCARD_SSID_LEN];
-	u8 				intent;		/* 	should only include the intent value. */
-	u8				p2p_peer_interface_addr[ETH_ALEN];
-	u8				p2p_peer_device_addr[ETH_ALEN];
-	u8 				peer_intent;	/* 	Included the intent value and tie breaker value. */
-	u8				device_name[WPS_MAX_DEVICE_NAME_LEN];	/*	Device name for displaying on searching device screen */
-	u8 				device_name_len;
-	u8 				profileindex;	/* 	Used to point to the index of profileinfo array */
-	u8 				peer_operating_ch;
-	u8 				find_phase_state_exchange_cnt;
-	u16 					device_password_id_for_nego;	/* 	The device password ID for group negotiation */
-	u8 				negotiation_dialog_token;
-	u8				nego_ssid[WLAN_SSID_MAXLEN];	/*	SSID information for group negotiation */
-	u8 				nego_ssidlen;
-	u8 				p2p_group_ssid[WLAN_SSID_MAXLEN];
-	u8 				p2p_group_ssid_len;
-	u8 				persistent_supported;		/* 	Flag to know the persistent function should be supported or not. */
-														/* 	In the Sigma test, the Sigma will provide this enable from the sta_set_p2p CAPI. */
-														/* 	0: disable */
-														/* 	1: enable */
-	u8 				session_available;			/* 	Flag to set the WFD session available to enable or disable "by Sigma" */
-														/* 	In the Sigma test, the Sigma will disable the session available by using the sta_preset CAPI. */
-														/* 	0: disable */
-														/* 	1: enable */
-
-	u8 				wfd_tdls_enable;			/* 	Flag to enable or disable the TDLS by WFD Sigma */
-														/* 	0: disable */
-														/* 	1: enable */
-	u8 				wfd_tdls_weaksec;			/* 	Flag to enable or disable the weak security function for TDLS by WFD Sigma */
-														/* 	0: disable */
-														/* 	In this case, the driver can't issue the tdsl setup request frame. */
-														/* 	1: enable */
-														/* 	In this case, the driver can issue the tdls setup request frame */
-														/* 	even the current security is weak security. */
-
-	enum	p2p_wpsinfo		ui_got_wps_info;			/* 	This field will store the WPS value (PIN value or PBC) that UI had got from the user. */
-	u16 					supported_wps_cm;			/* 	This field describes the WPS config method which this driver supported. */
-														/* 	The value should be the combination of config method defined in page104 of WPS v2.0 spec. */
-	u8 				external_uuid;				/*  UUID flag */
-	u8 				uuid[16];					/*  UUID */
-	uint						channel_list_attr_len;		/* 	This field will contain the length of body of P2P Channel List attribute of group negotitation response frame. */
-	u8 				channel_list_attr[100];		/* 	This field will contain the body of P2P Channel List attribute of group negotitation response frame. */
-														/* 	We will use the channel_cnt and channel_list fields when constructing the group negotitation confirm frame. */
-	u8 				driver_interface;			/* 	Indicate DRIVER_WEXT or DRIVER_CFG80211 */
-};
-
-struct tdls_ss_record {	/* signal strength record */
-	u8 macaddr[ETH_ALEN];
-	u8 rx_pwd_ba11;
-	u8 is_tdls_sta;	/*  true: direct link sta, false: else */
-};
-
 /* used for mlme_priv.roam_flags */
 enum {
 	RTW_ROAM_ON_EXPIRED = BIT0,
-- 
2.45.2