Re: [PATCH v5 0/3] extcon: usbc-tusb320: Initial TUSB320L support

[Chanwoo Choi <cw00.choi@samsung.com>]

On 9/25/21 2:45 PM, Yassine Oudjana wrote:
> The TUSB320L is a newer chip with additional features. It is close enough to TUSB320 so it works
> to some extent out-of-the-box, but for some reason it can start in UFP mode which is not desirable.
> 
> This series adds support for reset and mode setting for both chips, and does that while probing
> to ensure the chip starts with the default mode of following the PORT pin.
> 
> Changes since v4:
>  - Use ops struct instead of type enum.
> Changes since v3:
>  - Remove unused tusb_modes.
>  - Remove extra blank line.
> Changes since v2:
>  - Read state before setting default mode, then update it again after resetting.
>  - Remove mode tracing from irq handler
>  - Add a delay after reset to handle tSOFT_RESET
>  - Use a separate mode setting function for each of TUSB320 and TUSB320L.
> Changes since v1:
>  - Split first patch into two patches, one adding support for mode setting and reset on TUSB320,
>    and the other adding support for TUSB320L.
>  - Fix dt_binding_check warning:
>    ../Documentation/devicetree/bindings/extcon/extcon-usbc-tusb320.yaml:15:6: [warning] wrong indentation: expected 6 but found 5 (indentation)
> 
> Yassine Oudjana (3):
>   extcon: usbc-tusb320: Add support for mode setting and reset
>   extcon: usbc-tusb320: Add support for TUSB320L
>   dt-bindings: extcon: usbc-tusb320: Add TUSB320L compatible string
> 
>  .../bindings/extcon/extcon-usbc-tusb320.yaml  |   4 +-
>  drivers/extcon/extcon-usbc-tusb320.c          | 163 +++++++++++++++++-
>  2 files changed, 161 insertions(+), 6 deletions(-)
> 

Thanks for fixup. Applied them.

-- 
Best Regards,
Chanwoo Choi
Samsung Electronics