From: Tim Coleman <tim@timcoleman.com>
To: Jeff Garzik <garzik@havoc.gtf.org>
Cc: linux-kernel@vger.kernel.org
Subject: usb-storage (was: Re: Oops in 2.5.1)
Date: 31 Jan 2002 22:30:24 -0500 [thread overview]
Message-ID: <1012534229.1148.7.camel@tux.epenguin.org> (raw)
In-Reply-To: <20020130221605.C22862@havoc.gtf.org>
In-Reply-To: <1012445595.7956.4.camel@tux.epenguin.org> <20020130221605.C22862@havoc.gtf.org>
On Wed, 2002-01-30 at 22:16, Jeff Garzik wrote:
> On Wed, Jan 30, 2002 at 09:53:13PM -0500, Tim Coleman wrote:
> > I got an oops when loading usb with hotplug in kernel 2.5.1
> > I realize that this isn't the current version but I thought
> > I would send it in anyway, because I haven't got 2.5.3 yet.
> >
> > The device is not accessible at all with this kernel, and I notice
> > that the trace mentions the 8139_too ethernet driver.
>
> Can you rebuild with 8139too and USB inside the kernel, instead of
> modules, and attempt to reproduce?
>
> 8139 has a bunch of assert() calls in that area, which make me doubt the
> veracity of the ksymoops output :/
>
> Also make sure you are sending the oops through the proper system.map...
>
I can't really compile the 8139too into the kernel because I have two of
them. :)
I just tried 2.5.3, and I didn't get an oops, but the device wasn't
loaded correctly either. It works fine in the last 2.4.x kernel I used
(2.4.14).
Jan 31 22:19:09 tux kernel: hub.c: new USB device on bus 1 path /2,
assigned address 2
Jan 31 22:19:09 tux kernel: usb.c: USB device 2 (vend/prod 0x54c/0x2e)
is not claimed by any active driver.
Jan 31 22:19:09 tux /etc/hotplug/usb.agent: Setup usb-storage for USB
product 54c/2e/300
Jan 31 22:19:09 tux kernel: Initializing USB Mass Storage driver...
Jan 31 22:19:09 tux kernel: usb.c: registered new driver usb-storage
Jan 31 22:19:09 tux kernel: scsi0 : SCSI emulation for USB Mass Storage
devices
Jan 31 22:19:09 tux kernel: Vendor: Sony Model: Sony DSC
Rev: 3.00
Jan 31 22:19:09 tux kernel: Type: Direct-Access
ANSI SCSI revision: 02
Jan 31 22:19:09 tux kernel: Attached scsi removable disk sda at scsi0,
channel 0, id 0, lun 0
Jan 31 22:19:09 tux kernel: SCSI device sda: 7904 512-byte hdwr sectors
(4 MB)
Jan 31 22:19:09 tux kernel: sda: Write Protect is off
Jan 31 22:19:09 tux kernel:
/dev/scsi/host0/bus0/target0/lun0:<4>usb-uhci.c: interrupt, status 28,
frame# 1841
Jan 31 22:19:09 tux kernel: usb-uhci.c: Host controller halted, trying
to restart.
Jan 31 22:19:09 tux last message repeated 31 times
Jan 31 22:19:39 tux kernel: usb-uhci.c: interrupt, status 28, frame#
1128
Jan 31 22:19:39 tux kernel: usb-uhci.c: Host controller halted, trying
to restart.
Jan 31 22:19:39 tux last message repeated 31 times
Jan 31 22:20:09 tux kernel: usb-uhci.c: interrupt, status 3, frame# 396
Jan 31 22:20:09 tux kernel: usb.c: USB disconnect on device 2
Jan 31 22:20:10 tux kernel: hub.c: new USB device on bus 1 path /2,
assigned address 3
Jan 31 22:20:14 tux kernel: usb-storage: host_reset() requested but not
implemented
Jan 31 22:20:24 tux kernel: scsi: device set offline - command error
recover failed: host 0 channel 0 id 0 lun 0
Jan 31 22:20:24 tux kernel: SCSI disk error : host 0 channel 0 id 0 lun
0 return code = 6050000
Jan 31 22vim :20:24 tux kernel: end_request: I/O error, dev 08:00,
sector 0
Jan 31 22:20:24 tux kernel: end_request: I/O error, dev 08:00, sector 2
Jan 31 22:20:24 tux kernel: end_request: I/O error, dev 08:00, sector 0
Jan 31 22:20:24 tux kernel: unable to read partition table
Jan 31 22:20:24 tux kernel: WARNING: USB Mass Storage data integrity not
assured
Jan 31 22:20:24 tux kernel: USB Mass Storage device found at 2
Jan 31 22:20:24 tux kernel: USB Mass Storage support registered.
Jan 31 22:20:25 tux /etc/hotplug/usb.agent: missing kernel or user mode
driver usb-storage
Jan 31 22:20:25 tux kernel: scsi1 : SCSI emulation for USB Mass Storage
devices
Jan 31 22:20:25 tux kernel: WARNING: USB Mass Storage data integrity not
assured
Jan 31 22:20:25 tux kernel: USB Mass Storage device found at 3
Jan 31 22:20:25 tux /etc/hotplug/usb.agent: Setup usb-storage for USB
product 54c/2e/300
Jan 31 22:20:25 tux /etc/hotplug/usb.agent: missing kernel or user mode
driver usb-storage
lsmod shows that the driver is loaded
tux:/etc# lsmod
Module Size Used by Not tainted
vfat 9596 0 (autoclean)
fat 30648 0 (autoclean) [vfat]
usb-storage 20476 0 (unused)
ipt_MASQUERADE 1376 1 (autoclean)
iptable_nat 14644 1 (autoclean) [ipt_MASQUERADE]
ipt_state 768 2 (autoclean)
ip_conntrack 14284 2 (autoclean) [ipt_MASQUERADE
iptable_nat ipt_state]
iptable_filter 1920 1 (autoclean)
ip_tables 10816 6 [ipt_MASQUERADE iptable_nat ipt_state
iptable_filter]
parport_pc 12612 1 (autoclean)
lp 6112 0 (autoclean)
parport 14368 1 (autoclean) [parport_pc lp]
8139too 12864 2 (autoclean)
crc32 872 1 (autoclean) [8139too]
sd_mod 9400 0 (autoclean)
scsi_mod 66808 3 (autoclean) [usb-storage sd_mod]
usb-uhci 21604 0 (unused)
usbcore 55756 1 [usb-storage usb-uhci]
es1371 27232 1
ac97_codec 9728 0 [es1371]
gameport 1628 0 [es1371]
--
Tim Coleman <tim@timcoleman.com> [43.28 N 80.31 W]
BMath, Honours Combinatorics and Optimization, University of Waterloo
"They that can give up essential liberty to obtain a little temporary
safety deserve neither liberty nor safety." -- Benjamin Franklin
next prev parent reply other threads:[~2002-02-01 3:31 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
2002-01-31 2:53 Oops in 2.5.1 Tim Coleman
2002-01-31 3:16 ` Jeff Garzik
2002-02-01 3:30 ` Tim Coleman [this message]
2002-02-01 3:39 ` usb-storage (was: Re: Oops in 2.5.1) Jeff Garzik
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1012534229.1148.7.camel@tux.epenguin.org \
--to=tim@timcoleman.com \
--cc=garzik@havoc.gtf.org \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®