Hello. I'll start with the ECC memory problem.... Recently got the goahead to upgrade the Gateway Win2K server to a linux box to replace out old webserver. It's a 6400 server. 2 PIII-733's, 704 megs ECC registered ram.. NT ran fine on this box. not a hitch. Going to install Suse 7.3 on it and ran into some slowness problems. Once the kernel was booted and the install programs were running thigns slowed to a crawl. After an hour of messing around. I started to pull memory and CPU's out. Turns out the 512meg DIMM ECC ram was the cause of the slowness problem. No error messages no nothing. looks like the ECC was doing it's thing. But created a CPU useage of 100% all the time... Is there a kernel switch I can flip to make it place nice with broken ECC ram? or is this ram just worthless? Now the real issue. I searched all over google and this mailing list to see if I'm the only one. But looks like I am. Infact, I seen nothing but priase for this box with linux running on it. In a non-SMP kernel this machien runs perfectly. Not a hitch.. When booted with an SMP kernel. Once the load hits 1.4, the machine locks up like a rock. I have to hit the reset button. I turned off MP 1.4 spec, all power management is turned off any goodies in bios are off. I even upgraded the BIOS to the latest version. No luck. I been suggested to try the 2.2 kernel, but since the root partition is reiserfs and namesys.com has been down all weekend. I'm not able to get a 2.2 kernel running with reiserfs support.. I'll try 2.2.20 as soon as I can DL the resierfs patch. I have attached the dmesg for this box. Any suggestions or patches or anything I'll try. Also I would like to note that the second CPU is the exact same stepping and speed. But was installed well after the machine was purchased. -- Jason Czerak