Re: PDC20267 + RAID can't find raid device

[Samuel Flory <sflory@rackable.com>]

  It works for me once I got the right options.  Did you enable the
"fasttrak feature"

I'm using the following options in my .config:
CONFIG_BLK_DEV_PDC202XX=y
CONFIG_PDC202XX_BURST=y
CONFIG_PDC202XX_FORCE=y
CONFIG_BLK_DEV_ATARAID_PDC=y

  One major issue for me is that you can use, and mount both the
/dev/ataraid/d0 devices, and the /dev/hd devices.  This makes for lots
of fun in the Red Hat installer, and Cerberus.   


On Thu, 2002-06-06 at 08:19, William Thompson wrote:
> After trying 2.4.19-pre10-ac2 I can finally use the PDC20267 controller,
> however, it doesn't find any raid devices.
> 
> I have 2 quantum fireballlct10 05 on the controller (hde and hdg) and
> created a stripe between these 2 disks in the controller's bios.
> 
> I can see both disks w/o problems.
> 
> I'd rather not use the linux software raid since you can't partition it.
> 
> IDE, PDC20267, FastTrak, and the raid driver are all compiled into the
> kernel.
> 
> More info is available at request.
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at  http://www.tux.org/lkml/
>