Hi, I'm getting a system lockup when I insert a USB storage device (either a IBM memory key, or a USB MemoryStick reader). It seems to happen after I've done a suspend/resume cycle. If I insert the device on a freshly booted system it doesn't lock up. In the lockup case, it prints: hub 1-0:0: debounce: port 3: delay 100ms stable 4 status 0x501. and then goes completely silent - the cursor stops blinking and alt-sysreq doesn't respond. When I insert the same device on a fresh boot, it looks like it does all the right things: hub 1-0:0: debounce: port 3: delay 100ms stable 4 status 0x501 hub 3-0:0: debounce: port 1: delay 100ms stable 4 status 0x101 hub 3-0:0: new USB device on port 1, assigned address 2 usb 3-1: USB device not accepting new address=2 (error=-110) hub 3-0:0: new USB device on port 1, assigned address 3 Initializing USB Mass Storage driver... scsi0 : SCSI emulation for USB Mass Storage devices Vendor: IBM Model: Memory Key Rev: 3.04 Type: Direct-Access ANSI SCSI revision: 02 SCSI device sda: 127840 512-byte hdwr sectors (65 MB) sda: Write Protect is off sda: Mode Sense: 00 46 00 00 but trying to open /dev/sda or /dev/sda1 gives ENXIO. I've attached the /proc/bus/usb/devices before and after insertion; my .config; the output of lspci and lsusb; my loaded modules and the full dmesg output. "cat /proc/scsi/scsi" hangs forever. This is an IBM ThinkPad X31, which uses the Intel i855PM chipset, which includes USB 1.1 and USB 2.0. I think this IBM memory stick supports USB2, though it only seems to be recognized as a USB 1.1 device. Any ideas? Thanks, J