From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S261551AbUEAVdN (ORCPT ); Sat, 1 May 2004 17:33:13 -0400 Received: (majordomo@vger.kernel.org) by vger.kernel.org id S261580AbUEAVdN (ORCPT ); Sat, 1 May 2004 17:33:13 -0400 Received: from outmx009.isp.belgacom.be ([195.238.3.4]:25550 "EHLO outmx009.isp.belgacom.be") by vger.kernel.org with ESMTP id S261551AbUEAVdJ (ORCPT ); Sat, 1 May 2004 17:33:09 -0400 Subject: [OOPS 2.6.6-rc2] quota / sda1 From: FabF To: lkml Content-Type: text/plain Message-Id: <1083447548.6718.12.camel@bluerhyme.real3> Mime-Version: 1.0 X-Mailer: Ximian Evolution 1.4.6 Date: Sat, 01 May 2004 23:39:10 +0200 Content-Transfer-Encoding: 7bit X-RAVMilter-Version: 8.4.3(snapshot 20030212) (outmx009.isp.belgacom.be) Sender: linux-kernel-owner@vger.kernel.org X-Mailing-List: linux-kernel@vger.kernel.org Hi, Using quota v2 / Linux 2.6.6-rc2 on usb storage, I've got following results : EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Freeing unused kernel memory: 240k freed usb 2-1: new full speed USB device using address 2 scsi0 : SCSI emulation for USB Mass Storage devices Vendor: xxx Model: xxx Rev: 1.30 Type: Direct-Access ANSI SCSI revision: 02 SCSI device sda: 31745 512-byte hdwr sectors (16 MB) sda: assuming Write Enabled sda: assuming drive cache: write through sda: sda1 Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0 Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0, type 0 USB Mass Storage device found at 2 hub 3-0:1.0: over-current change on port 2 ... kjournald starting. Commit interval 5 seconds EXT3 FS on sda1, internal journal EXT3-fs: mounted filesystem with ordered data mode. scsi: Device offlined - not ready after error recovery: host 0 channel 0 id 0 lun 0 SCSI error : <0 0 0 0> return code = 0x70000 end_request: I/O error, dev sda, sector 11298 Buffer I/O error on device sda1, logical block 5633 scsi0 (0:0): rejecting I/O to offline device Buffer I/O error on device sda1, logical block 5634 Buffer I/O error on device sda1, logical block 5635 Buffer I/O error on device sda1, logical block 5636 Buffer I/O error on device sda1, logical block 5637 Buffer I/O error on device sda1, logical block 5638 Buffer I/O error on device sda1, logical block 5639 scsi0 (0:0): rejecting I/O to offline device Buffer I/O error on device sda1, logical block 5638 scsi0 (0:0): rejecting I/O to offline device Buffer I/O error on device sda1, logical block 5633 Buffer I/O error on device sda1, logical block 5634 Buffer I/O error on device sda1, logical block 5635 usb 2-1: USB disconnect, address 2 sd 0:0:0:0: Illegal state transition offline->cancel Badness in scsi_device_set_state at drivers/scsi/scsi_lib.c:1640 Call Trace: [] scsi_device_set_state+0xcd/0x120 [] scsi_device_cancel+0x29/0xf5 [] scsi_device_cancel_cb+0x0/0x20 [] device_for_each_child+0x49/0x80 [] scsi_host_cancel+0x35/0xb0 [] scsi_device_cancel_cb+0x0/0x20 [] usb_buffer_free+0x52/0x60 [] scsi_remove_host+0x1b/0x60 [] storage_disconnect+0x38/0x48 [] usb_unbind_interface+0x78/0x80 [] device_release_driver+0x66/0x70 [] bus_remove_device+0x54/0xa0 [] device_del+0x5d/0xa0 [] device_unregister+0x13/0x30 [] usb_disable_device+0x70/0xb0 [] usb_disconnect+0x96/0xf0 [] hub_port_connect_change+0x281/0x290 [] hub_port_status+0x43/0xb0 [] hub_events+0x316/0x360 [] hub_thread+0x35/0xf0 [] default_wake_function+0x0/0x20 [] hub_thread+0x0/0xf0 [] kernel_thread_helper+0x5/0x10 It appears on both ext2/ext3 and should be scsi (emulation) relevant only... I tried adding usrquota in fstab after boot.It works perfectly... Regards, FabF