@@ -77,13 +68,31 @@
 ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.AGP_._PRT]
 ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.PCI1._PRT]
 PCI: Using ACPI for IRQ routing
-** PCI interrupts are no longer routed automatically.  If this
-** causes a device to stop working, it is probably because the
-** driver failed to call pci_enable_device().  As a temporary
-** workaround, the "pci=routeirq" argument restores the old
-** behavior.  If this argument makes the device work again,
+** Routing PCI interrupts for all devices because "pci=routeirq"
+** was specified.  If this was required to make a driver work,
 ** please email the output of "lspci" to bjorn.helgaas@hp.com
 ** so I can fix the driver.
+ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 11
+PCI: setting IRQ 11 as level-triggered
+ACPI: PCI interrupt 0000:00:1d.0[A] -> GSI 11 (level, low) -> IRQ 11
+ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 11
+ACPI: PCI interrupt 0000:00:1d.1[B] -> GSI 11 (level, low) -> IRQ 11
+ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 11
+ACPI: PCI interrupt 0000:00:1d.2[C] -> GSI 11 (level, low) -> IRQ 11
+ACPI: PCI Interrupt Link [LNKH] enabled at IRQ 11
+ACPI: PCI interrupt 0000:00:1d.7[D] -> GSI 11 (level, low) -> IRQ 11
+ACPI: PCI interrupt 0000:00:1f.1[A] -> GSI 11 (level, low) -> IRQ 11
+ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 5
+PCI: setting IRQ 5 as level-triggered
+ACPI: PCI interrupt 0000:00:1f.3[B] -> GSI 5 (level, low) -> IRQ 5
+ACPI: PCI interrupt 0000:00:1f.5[B] -> GSI 5 (level, low) -> IRQ 5
+ACPI: PCI interrupt 0000:00:1f.6[B] -> GSI 5 (level, low) -> IRQ 5
+ACPI: PCI interrupt 0000:01:00.0[A] -> GSI 11 (level, low) -> IRQ 11
+ACPI: PCI interrupt 0000:02:00.0[A] -> GSI 11 (level, low) -> IRQ 11
+ACPI: PCI interrupt 0000:02:00.1[B] -> GSI 5 (level, low) -> IRQ 5
+ACPI: PCI interrupt 0000:02:00.2[C] -> GSI 11 (level, low) -> IRQ 11
+ACPI: PCI interrupt 0000:02:01.0[A] -> GSI 11 (level, low) -> IRQ 11
+ACPI: PCI interrupt 0000:02:02.0[A] -> GSI 11 (level, low) -> IRQ 11
 TC classifier action (bugs to netdev@oss.sgi.com cc hadi@cyberus.ca)
 Simple Boot Flag at 0x35 set to 0x1
 Total HugeTLB memory allocated, 0
@@ -105,8 +114,6 @@
 serio: i8042 AUX port at 0x60,0x64 irq 12
 serio: i8042 KBD port at 0x60,0x64 irq 1
 Serial: 8250/16550 driver $Revision: 1.90 $ 8 ports, IRQ sharing disabled
-ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 5
-PCI: setting IRQ 5 as level-triggered
 ACPI: PCI interrupt 0000:00:1f.6[B] -> GSI 5 (level, low) -> IRQ 5
 io scheduler noop registered
 io scheduler anticipatory registered
@@ -117,8 +124,6 @@
 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
 ICH4: IDE controller at PCI slot 0000:00:1f.1
 PCI: Enabling device 0000:00:1f.1 (0005 -> 0007)
-ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 11
-PCI: setting IRQ 11 as level-triggered
 ACPI: PCI interrupt 0000:00:1f.1[A] -> GSI 11 (level, low) -> IRQ 11
 ICH4: chipset revision 1
 ICH4: not 100% native mode: will probe irqs later
@@ -178,7 +183,6 @@
 EXT3-fs: mounted filesystem with ordered data mode.
 Linux Kernel Card Services
   options:  [pci] [cardbus] [pm]
-ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 11
 ACPI: PCI interrupt 0000:02:00.0[A] -> GSI 11 (level, low) -> IRQ 11
 Yenta: CardBus bridge found at 0000:02:00.0 [1014:0532]
 Yenta: ISA IRQ mask 0x0498, PCI irq 11
@@ -219,11 +223,10 @@
 PCI: Setting latency timer of device 0000:00:1d.0 to 64
 uhci_hcd 0000:00:1d.0: irq 11, io base 0x1800
 uhci_hcd 0000:00:1d.0: new USB bus registered, assigned bus number 1
-hub 1-0:1.0: USB hub found
-hub 1-0:1.0: 2 ports detected
 eth1394: $Rev: 1224 $ Ben Collins <bcollins@debian.org>
 eth1394: eth1: IEEE-1394 IPv4 over 1394 Ethernet (fw-host0)
-ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 11
+hub 1-0:1.0: USB hub found
+hub 1-0:1.0: 2 ports detected
 ACPI: PCI interrupt 0000:00:1d.1[B] -> GSI 11 (level, low) -> IRQ 11
 uhci_hcd 0000:00:1d.1: Intel Corp. 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) USB UHCI Controller #2
 PCI: Setting latency timer of device 0000:00:1d.1 to 64
@@ -238,7 +241,6 @@
 uhci_hcd 0000:00:1d.2: new USB bus registered, assigned bus number 3
 hub 3-0:1.0: USB hub found
 hub 3-0:1.0: 2 ports detected
-ACPI: PCI Interrupt Link [LNKH] enabled at IRQ 11
 ACPI: PCI interrupt 0000:00:1d.7[D] -> GSI 11 (level, low) -> IRQ 11
 ehci_hcd 0000:00:1d.7: Intel Corp. 82801DB/DBM (ICH4/ICH4-M) USB 2.0 EHCI Controller
 PCI: Setting latency timer of device 0000:00:1d.7 to 64