[PATCH net-next v2 4/8] net: dsa: realtek: rtl8365mb: set RGMII mode for family D

[Mieczyslaw Nalewaj <namiltd@yahoo.com>]

On family D, RGMII on extension interface 1 needs two things that the
other families do not: the EXT1 RGMII TX clock delay field in
EXT_TXC_DLY (0x13f9, bits [5:3]) must be cleared, and the pin mux in
the top-level configuration register must be set up.

The vendor RGMII setup for EXT1 clears the RGMII field of EXT_TXC_DLY
(0x13f9, bits [5:3]) in addition to programming TXDELAY in RGMXF.
Do the same. The init jam table writes 0x0090 to this register, which
leaves the field at 2, so without the clear an extra TX delay would be
applied on top of tx-internal-delay-ps. Clearing it makes
tx-internal-delay-ps the only source of TX delay.

If the internal MAC4 block is not occupying extension 1, bind the
RGMII/MII pins to MAC7. SerDes 1, which shares the pins, is always
disabled.

Signed-off-by: Mieczyslaw Nalewaj <namiltd@yahoo.com>
---
 drivers/net/dsa/realtek/rtl8365mb_main.c | 47 ++++++++++++++++++++++++
 1 file changed, 47 insertions(+)

diff --git a/drivers/net/dsa/realtek/rtl8365mb_main.c b/drivers/net/dsa/realtek/rtl8365mb_main.c
index b1ea8b0..3819a48 100644
--- a/drivers/net/dsa/realtek/rtl8365mb_main.c
+++ b/drivers/net/dsa/realtek/rtl8365mb_main.c
@@ -334,6 +334,12 @@
 #define   RTL8365MB_SDS_OPTION_ARM_KEY		0x0249
 #define RTL8365MB_SDS_OPTION_REG		0x13C1
 
+#define RTL8365MB_D_SDS_MISC_MODE_FIELD_MASK		GENMASK(4, 0)
+/* Shared "disable" encoding for both SDS_MISC's and SDS1_MISC0's
+ * 5-bit mode fields.
+ */
+#define RTL8365MB_D_PORT_SDS_MODE_DISABLE		0x1f
+
 /* Embedded DW8051 microcontroller control registers. The microcontroller
  * can run firmware to manage the SerDes link, but this driver keeps it in
  * reset and disabled: phylink already performs the link management that
@@ -459,6 +465,20 @@
 #define   RTL8365MB_PORT_MISC_CFG_VLAN_EGRESS_MODE_MASK		GENMASK(5, 4)
 #define   RTL8365MB_PORT_MISC_CFG_CONGESTION_SUSTAIN_TIME_MASK	GENMASK(3, 0)
 
+/* EXT_TXC_DLY holds a 3-bit TX clock delay per external interface, for
+ * RGMII ([2:0] EXT0, [5:3] EXT1, [8:6] EXT2) and separately for GMII.
+ * Only the EXT1 RGMII field is used here, and it is cleared in RGMII
+ * mode so that tx-internal-delay-ps is the only TX delay applied.
+ */
+#define RTL8365MB_D_REG_EXT_TXC_DLY				0x13f9
+#define   RTL8365MB_D_EXT1_RGMII_TX_DLY_MASK			GENMASK(5, 3)
+
+#define RTL8365MB_D_REG_TOP_CON0				0x1d70
+#define   RTL8365MB_D_MAC7_SEL_EXT1_MASK			BIT(13)
+#define   RTL8365MB_D_MAC4_SEL_EXT1_MASK			BIT(12)
+
+#define RTL8365MB_D_REG_SDS1_MISC0				0x1d78
+
 /**
  * enum rtl8365mb_vlan_egress_mode - port VLAN egress mode
  * @RTL8365MB_VLAN_EGRESS_MODE_ORIGINAL: follow untag mask in VLAN4k table entry
@@ -1208,6 +1228,7 @@ static int rtl8365mb_ext_config_rgmii(struct realtek_priv *priv, int port,
 	struct dsa_port *dp;
 	int tx_delay = 0;
 	int rx_delay = 0;
+	u32 data;
 	u32 val;
 	int ret;
 
@@ -1277,6 +1298,32 @@ static int rtl8365mb_ext_config_rgmii(struct realtek_priv *priv, int port,
 	if (ret)
 		return ret;
 
+	if (rtl8365mb_get_family(priv) == RTL8365MB_FAMILY_D && extint->id == 1) {
+		ret = regmap_update_bits(priv->map,
+					 RTL8365MB_D_REG_EXT_TXC_DLY,
+					 RTL8365MB_D_EXT1_RGMII_TX_DLY_MASK, 0);
+		if (ret)
+			return ret;
+		/* Configure RGMII/MII mux to port 7 if UTP_PORT4 is not RGMII mode */
+		ret = regmap_read(priv->map, RTL8365MB_D_REG_TOP_CON0, &data);
+		if (ret)
+			return ret;
+		if ((data & RTL8365MB_D_MAC4_SEL_EXT1_MASK) == 0) {
+			ret = regmap_update_bits(priv->map,
+						 RTL8365MB_D_REG_TOP_CON0,
+						 RTL8365MB_D_MAC7_SEL_EXT1_MASK,
+						 RTL8365MB_D_MAC7_SEL_EXT1_MASK);
+			if (ret)
+				return ret;
+		}
+		ret = regmap_update_bits(priv->map,
+					 RTL8365MB_D_REG_SDS1_MISC0,
+					 RTL8365MB_D_SDS_MISC_MODE_FIELD_MASK,
+					 RTL8365MB_D_PORT_SDS_MODE_DISABLE);
+		if (ret)
+			return ret;
+	}
+
 	return 0;
 }
 
-- 
2.53.0