From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1752850Ab0CRRAF (ORCPT ); Thu, 18 Mar 2010 13:00:05 -0400 Received: from ovro.ovro.caltech.edu ([192.100.16.2]:56401 "EHLO ovro.ovro.caltech.edu" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1752712Ab0CRRAA (ORCPT ); Thu, 18 Mar 2010 13:00:00 -0400 From: "Ira W. Snyder" To: linux-kernel@vger.kernel.org Cc: netdev@vger.kernel.org, sameo@linux.intel.com, socketcan-core@lists.berlios.de Subject: [PATCH 0/3] add support for Janz MODULbus devices Date: Thu, 18 Mar 2010 09:38:41 -0700 Message-Id: <1268930324-29841-1-git-send-email-iws@ovro.caltech.edu> X-Mailer: git-send-email 1.5.4.3 In-Reply-To: <> References: <> X-Greylist: Sender succeeded SMTP AUTH, not delayed by milter-greylist-4.0 (ovro.ovro.caltech.edu); Thu, 18 Mar 2010 09:38:44 -0700 (PDT) Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org This patch series adds support for the Janz CMOD-IO carrier board, as well as the Janz VMOD-ICAN3 Intelligent CAN controller and the Janz VMOD-TTL Digital IO controller. The CMOD-IO carrier board is a PCI to MODULbus bridge, into which plug MODULbus daughterboards. I only have access to two types of daughtercards, the VMOD-ICAN3 and VMOD-TTL boards mentioned above. The CAN driver has been tested under high loads. I am able to generate ~60% bus utilization. With two VMOD-ICAN3 boards looped back to each other, neither one loses any packets when only a single board is generating packets at maximum speed. Once both boards start generating packets, one board will sometimes loose arbitration, and cause some lost packets. RFCv3 -> RFCv4: - addressed many review comments - switch to NAPI - add TX flow control - mark functions with __devinit and __devexit - add sysfs readout of MODULbus number (hex switch) - implement GPIO driver for VMOD-TTL RFCv2 -> RFCv3: - addressed many review comments - correct CAN bus error handling - use struct device to track subdevices - use structures for register layout - add lots of #defines for register values - use better function prefixes RFCv1 -> RFCv2: - converted to a multi-driver model - addressed many review comments - added CAN bus error handling - use a work function only instead of work + NAPI - use SJA1000 bittiming calculation code I apologize if I've CC'd too many people here, but I'm unsure if people would rather see the whole patch series, or just each part. I appreciate any review you can offer. Thanks, Ira