Re: [PATCH 1/2] dmar: fix fault interrupt setup

[Suresh Siddha <suresh.b.siddha@intel.com>]

On Tue, 2010-11-30 at 00:30 -0800, Kenji Kaneshige wrote: 
> Fix the problem dmar fault event is not notified in x2apic cluster mode.
> 
> In the current code, dmar fault event is configured before setting up
> the x86_cpu_to_logical_apicid percpu variable in x2apic cluster
> mode. Because of this, invalid apic ID is used for dmar fault
> interrupt and this cuases the problem.
> 
> To fix the problem, do dmar fault event configuration after local apic
> setup (after end_local_APIC_setup()).
> 
> Signed-off-by: Kenji Kaneshige <kaneshige.kenji@jp.fujitsu.com>
> 
> 
> ---
>  arch/x86/kernel/apic/apic.c     |    9 +++++++++
>  arch/x86/kernel/apic/probe_64.c |    7 -------
>  2 files changed, 9 insertions(+), 7 deletions(-)
> 
> Index: linux-next-20101125/arch/x86/kernel/apic/apic.c
> ===================================================================
> --- linux-next-20101125.orig/arch/x86/kernel/apic/apic.c
> +++ linux-next-20101125/arch/x86/kernel/apic/apic.c
> @@ -1745,6 +1745,15 @@ int __init APIC_init_uniprocessor(void)
>  
>  	end_local_APIC_setup();
>  
> +#ifdef CONFIG_INTR_REMAP
> +	/*
> +	 * Now that local APIC setup is completed, configure the fault
> +	 * handling for interrupt remapping.
> +	 */
> +	if (intr_remapping_enabled)
> +		enable_drhd_fault_handling();
> +#endif

BTW, this is wrong. APIC_init_uniprocessor() gets called only for UP
kernel. I will move it to the end_local_APIC_setup()

> +
>  #ifdef CONFIG_X86_IO_APIC
>  	if (smp_found_config && !skip_ioapic_setup && nr_ioapics)
>  		setup_IO_APIC();
> Index: linux-next-20101125/arch/x86/kernel/apic/probe_64.c
> ===================================================================
> --- linux-next-20101125.orig/arch/x86/kernel/apic/probe_64.c
> +++ linux-next-20101125/arch/x86/kernel/apic/probe_64.c
> @@ -79,13 +79,6 @@ void __init default_setup_apic_routing(v
>  		/* need to update phys_pkg_id */
>  		apic->phys_pkg_id = apicid_phys_pkg_id;
>  	}
> -
> -	/*
> -	 * Now that apic routing model is selected, configure the
> -	 * fault handling for intr remapping.
> -	 */
> -	if (intr_remapping_enabled)
> -		enable_drhd_fault_handling();
>  }
>  
>  /* Same for both flat and physical. */
> 
>