Re: [PATCH net-next v7 04/10] net: dsa: realtek: rtl8365mb: set RGMII mode for family D

[Mieczyslaw Nalewaj <namiltd@yahoo.com>]

Subject: Re: [PATCH net-next v7 04/10] net: dsa: realtek: rtl8365mb: set RGMII mode for family D

On Fri, Nov 06, 2026 at 02:50:46PM +0100, Alvin Šipraga wrote:
> Bookkeeping is overkill. Let's just not support MAC4 as anything other
> than UTP. If someone wants to add that support later, then it would make
> sense to add bookkeeping.

One more thing, since it affects how much I can verify. I do not have
RTL8367S-VB hardware or a test setup of my own, as I wrote to Luiz
earlier:

https://lore.kernel.org/netdev/9124a33c-55b5-4c7a-b8a7-25d0bd4e6936@yahoo.com/

> I cannot exercise FDB, VLAN filtering, STP or flooding controls myself.
> All testing so far was done by other users who run this code on their
> devices, and I depend on their reports.

This is why I could not read the reset default of MAC4_SEL_EXT1. For v9
I intend to make only the changes needed to address the open review
comments, and I will not extend the series beyond that. Further
verification of the shared code paths against the family D layout needs
someone with the hardware and a proper test setup.

Kind regards,
Mieczyslaw