Re: [Bugfix v4] PCI, ACPI: Fix regressions caused by resource_size_t overflow with 32-bit kernel

["Rafael J. Wysocki" <rjw@rjwysocki.net>]

On Wednesday, July 08, 2015 03:26:39 PM Jiang Liu wrote:
> Zoltan Boszormenyi reported this regression:
>   "There's a Realtek RTL8111/8168/8411 (PCI ID 10ec:8168, Subsystem ID
>    1565:230e) network chip on the mainboard. After the r8169 driver loaded
>    the IRQs in the machine went berserk. Keyboard keypressed arrived with
>    considerable latency and duplicated, so no real work was possible.
>    The machine responded to the power button but didn't actually power
>    down. It just stuck at the powering down message. I had to press the
>    power button for 4 seconds to power it down.
> 
>    The computer is a POS machine with a big battery inside. Because of this,
>    either ACPI or the Realtek chip kept the bad state and after rebooting,
>    the network chip didn't even show up in lspci. Not even the PXE ROM
>    announced itself during boot. I had to disconnect the battery to beat
>    some sense back to the computer.
> 
>    The regression happens with 4.0.5, 4.1.0-rc8 and 4.1.0-final. 3.18.16 was
>    good."
> 
> The regression is caused by commit 593669c2ac0f ("x86/PCI/ACPI: Use common
> ACPI resource interfaces to simplify implementation"). Since commit
> 593669c2ac0f, x86 PCI ACPI host bridge driver validates ACPI resources by
> first converting an ACPI resource to a 'struct resource' structure and
> then applying checks against the converted resource structure. The 'start'
> and 'end' fields in 'struct resource' are defined to be type of
> resource_size_t, which may be 32 bits or 64 bits depending on
> CONFIG_PHYS_ADDR_T_64BIT.
> 
> This may cause incorrect resource validation results with 32-bit kernels
> because 64-bit ACPI resource descriptors may get truncated when converting
> to 32-bit 'start' and 'end' fields in 'struct resource'. It eventually
> affects PCI resource allocation subsystem and makes some PCI devices and
> the system behave abnormally due to incorrect resource assignment.
> 
> So enhance the ACPI resource parsing interfaces to ignore ACPI resource
> descriptors with address/offset above 4G when running in 32-bit mode.
> 
> With the fix applied, the behavior of the machine was restored to how
> 3.18.16 worked, i.e. the memory range that is over 4GB is ignored again,
> and lspci -vvxxx shows that everything is at the same memory window as
> they were with 3.18.16.
> 
> Reported-and-Tested-by: Boszormenyi Zoltan <zboszor@pr.hu>
> Fixes: 593669c2ac0f ("x86/PCI/ACPI: Use common ACPI resource interfaces to simplify implementation")
> Signed-off-by: Jiang Liu <jiang.liu@linux.intel.com>
> Cc: stable@vger.kernel.org # 4.0

OK, I'm happy with the above changelog, so I'm going to apply the patch.

If anyone has any objections, please let me know.

Thanks,
Rafael