From: xiong <xiong@qca.qualcomm.com>
To: <davem@davemloft.net>, <netdev@vger.kernel.org>,
<linux-kernel@vger.kernel.org>
Cc: <qca-linux-team@qualcomm.com>, <nic-devel@qualcomm.com>,
xiong <xiong@qca.qualcomm.com>
Subject: [PATCH 06/11] atl1c: refine reg definition of REG_MASTER_CTRL
Date: Thu, 19 Apr 2012 16:01:26 +0800 [thread overview]
Message-ID: <1334822491-30129-7-git-send-email-xiong@qca.qualcomm.com> (raw)
In-Reply-To: <1334822491-30129-1-git-send-email-xiong@qca.qualcomm.com>
refine/update register REG_MASTER_CTRL definition according with
hardware spec.
Signed-off-by: xiong <xiong@qca.qualcomm.com>
Tested-by: Liu David <dwliu@qca.qualcomm.com>
---
drivers/net/ethernet/atheros/atl1c/atl1c_hw.h | 41 +++++++++++++----------
drivers/net/ethernet/atheros/atl1c/atl1c_main.c | 2 +-
2 files changed, 24 insertions(+), 19 deletions(-)
diff --git a/drivers/net/ethernet/atheros/atl1c/atl1c_hw.h b/drivers/net/ethernet/atheros/atl1c/atl1c_hw.h
index 6d73ac9..9779b83 100644
--- a/drivers/net/ethernet/atheros/atl1c/atl1c_hw.h
+++ b/drivers/net/ethernet/atheros/atl1c/atl1c_hw.h
@@ -148,26 +148,31 @@ int atl1c_phy_power_saving(struct atl1c_hw *hw);
#define REG_LTSSM_ID_CTRL 0x12FC
#define LTSSM_ID_EN_WRO 0x1000
+
+
/* Selene Master Control Register */
#define REG_MASTER_CTRL 0x1400
-#define MASTER_CTRL_SOFT_RST 0x1
-#define MASTER_CTRL_TEST_MODE_MASK 0x3
-#define MASTER_CTRL_TEST_MODE_SHIFT 2
-#define MASTER_CTRL_BERT_START 0x10
-#define MASTER_CTRL_OOB_DIS_OFF 0x40
-#define MASTER_CTRL_SA_TIMER_EN 0x80
-#define MASTER_CTRL_MTIMER_EN 0x100
-#define MASTER_CTRL_MANUAL_INT 0x200
-#define MASTER_CTRL_TX_ITIMER_EN 0x400
-#define MASTER_CTRL_RX_ITIMER_EN 0x800
-#define MASTER_CTRL_CLK_SEL_DIS 0x1000
-#define MASTER_CTRL_CLK_SWH_MODE 0x2000
-#define MASTER_CTRL_INT_RDCLR 0x4000
-#define MASTER_CTRL_REV_NUM_SHIFT 16
-#define MASTER_CTRL_REV_NUM_MASK 0xff
-#define MASTER_CTRL_DEV_ID_SHIFT 24
-#define MASTER_CTRL_DEV_ID_MASK 0x7f
-#define MASTER_CTRL_OTP_SEL 0x80000000
+#define MASTER_CTRL_OTP_SEL BIT(31)
+#define MASTER_DEV_NUM_MASK 0x7FUL
+#define MASTER_DEV_NUM_SHIFT 24
+#define MASTER_REV_NUM_MASK 0xFFUL
+#define MASTER_REV_NUM_SHIFT 16
+#define MASTER_CTRL_INT_RDCLR BIT(14)
+#define MASTER_CTRL_CLK_SEL_DIS BIT(12) /* 1:alwys sel pclk from
+ * serdes, not sw to 25M */
+#define MASTER_CTRL_RX_ITIMER_EN BIT(11) /* IRQ MODURATION FOR RX */
+#define MASTER_CTRL_TX_ITIMER_EN BIT(10) /* MODURATION FOR TX/RX */
+#define MASTER_CTRL_MANU_INT BIT(9) /* SOFT MANUAL INT */
+#define MASTER_CTRL_MANUTIMER_EN BIT(8)
+#define MASTER_CTRL_SA_TIMER_EN BIT(7) /* SYS ALIVE TIMER EN */
+#define MASTER_CTRL_OOB_DIS BIT(6) /* OUT OF BOX DIS */
+#define MASTER_CTRL_WAKEN_25M BIT(5) /* WAKE WO. PCIE CLK */
+#define MASTER_CTRL_BERT_START BIT(4)
+#define MASTER_PCIE_TSTMOD_MASK 3UL
+#define MASTER_PCIE_TSTMOD_SHIFT 2
+#define MASTER_PCIE_RST BIT(1)
+#define MASTER_CTRL_SOFT_RST BIT(0) /* RST MAC & DMA */
+#define DMA_MAC_RST_TO 50
/* Timer Initial Value Register */
#define REG_MANUAL_TIMER_INIT 0x1404
diff --git a/drivers/net/ethernet/atheros/atl1c/atl1c_main.c b/drivers/net/ethernet/atheros/atl1c/atl1c_main.c
index 729381a..796cc75 100644
--- a/drivers/net/ethernet/atheros/atl1c/atl1c_main.c
+++ b/drivers/net/ethernet/atheros/atl1c/atl1c_main.c
@@ -1179,7 +1179,7 @@ static int atl1c_reset_mac(struct atl1c_hw *hw)
* clearing, and should clear within a microsecond.
*/
AT_READ_REG(hw, REG_MASTER_CTRL, &master_ctrl_data);
- master_ctrl_data |= MASTER_CTRL_OOB_DIS_OFF;
+ master_ctrl_data |= MASTER_CTRL_OOB_DIS;
AT_WRITE_REGW(hw, REG_MASTER_CTRL, ((master_ctrl_data | MASTER_CTRL_SOFT_RST)
& 0xFFFF));
--
1.7.7
next prev parent reply other threads:[~2012-04-19 8:02 UTC|newest]
Thread overview: 13+ messages / expand[flat|nested] mbox.gz Atom feed top
2012-04-19 8:01 [PATCH 00/11] atl1c: update hardware settings - v2 xiong
2012-04-19 8:01 ` [PATCH 01/11] atl1c: threshold for ASPM is changed based on chip capability xiong
2012-04-19 8:01 ` [PATCH 02/11] atl1c: add module parameter for l1c_wait_until_idle xiong
2012-04-19 8:01 ` [PATCH 03/11] atl1c: update right threshold for TSO xiong
2012-04-19 8:01 ` [PATCH 04/11] atl1c: remove dmar_dly_cnt and dmaw_dly_cnt xiong
2012-04-19 8:01 ` [PATCH 05/11] atl1c: clear PCIE error status in atl1c_reset_pcie xiong
2012-04-19 8:01 ` xiong [this message]
2012-04-19 8:01 ` [PATCH 07/11] atl1c: clear bit MASTER_CTRL_CLK_SEL_DIS in atl1c_pcie_patch xiong
2012-04-19 8:01 ` [PATCH 08/11] atl1c: refine/update ASPM configuration xiong
2012-04-19 8:01 ` [PATCH 09/11] atl1c: refine atl1c_pcie_patch xiong
2012-04-19 8:01 ` [PATCH 10/11] atl1c: fix WoL(magic) issue for l2cb 1.1 xiong
2012-04-19 8:01 ` [PATCH 11/11] atl1c: remove MDIO_REG_ADDR_MASK in atl1c_mdio_read/write xiong
2012-04-20 0:17 ` [PATCH 00/11] atl1c: update hardware settings - v2 David Miller
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1334822491-30129-7-git-send-email-xiong@qca.qualcomm.com \
--to=xiong@qca.qualcomm.com \
--cc=davem@davemloft.net \
--cc=linux-kernel@vger.kernel.org \
--cc=netdev@vger.kernel.org \
--cc=nic-devel@qualcomm.com \
--cc=qca-linux-team@qualcomm.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®