From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1753561AbaF2Uug (ORCPT ); Sun, 29 Jun 2014 16:50:36 -0400 Received: from cantor2.suse.de ([195.135.220.15]:32893 "EHLO mx2.suse.de" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1750720AbaF2Uue (ORCPT ); Sun, 29 Jun 2014 16:50:34 -0400 From: =?UTF-8?q?Andreas=20F=C3=A4rber?= To: Michal Simek Cc: Andreas Olofsson , devicetree@vger.kernel.org, linux-arm-kernel@lists.infradead.org, linux-kernel@vger.kernel.org, =?UTF-8?q?Andreas=20F=C3=A4rber?= Subject: [PATCH 0/1] ARM: dts: zynq: Prepare Parallella Date: Sun, 29 Jun 2014 22:50:20 +0200 Message-Id: <1404075022-28745-1-git-send-email-afaerber@suse.de> X-Mailer: git-send-email 1.9.3 MIME-Version: 1.0 Content-Type: text/plain; charset=UTF-8 Content-Transfer-Encoding: 8bit Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Hello, This patch adds an initial device tree for the Parallella board. UART, SD card, Ethernet are enabled. Not yet enabled are HDMI (FPGA, ADV7513), QSPI and 2x USB. Where I'm a bit unsure is the PHY placement; placement as subnode of the GEM corresponds to what was in the downstream 3.12 based device tree. It is a separate chip on the board though, whereas GEM is on the SoC. Regards, Andreas Andreas Färber (1): ARM: dts: zynq: Add Parallella device tree arch/arm/boot/dts/Makefile | 4 ++- arch/arm/boot/dts/zynq-parallella.dts | 63 +++++++++++++++++++++++++++++++++++ 2 files changed, 66 insertions(+), 1 deletion(-) create mode 100644 arch/arm/boot/dts/zynq-parallella.dts -- 1.9.3