[PATCH 5/6] phy: omap-usb2: Balance pm_runtime_enable() on probe failure

[Roger Quadros <rogerq@ti.com>]

If probe fails then we need to call pm_runtime_disable() to balance
out the previous pm_runtime_enable() call. Else it will cause
unbalanced pm_runtime_enable() call in the succeding probe call.

This anomaly was observed when the call to devm_phy_create() failed
with -EPROBE_DEFER.

Signed-off-by: Roger Quadros <rogerq@ti.com>
---
 drivers/phy/phy-omap-usb2.c | 8 ++++++--
 1 file changed, 6 insertions(+), 2 deletions(-)

diff --git a/drivers/phy/phy-omap-usb2.c b/drivers/phy/phy-omap-usb2.c
index 7007c11..c6f9809 100644
--- a/drivers/phy/phy-omap-usb2.c
+++ b/drivers/phy/phy-omap-usb2.c
@@ -265,15 +265,19 @@ static int omap_usb2_probe(struct platform_device *pdev)
 	pm_runtime_enable(phy->dev);
 
 	generic_phy = devm_phy_create(phy->dev, &ops, NULL);
-	if (IS_ERR(generic_phy))
+	if (IS_ERR(generic_phy)) {
+		pm_runtime_disable(phy->dev);
 		return PTR_ERR(generic_phy);
+	}
 
 	phy_set_drvdata(generic_phy, phy);
 
 	phy_provider = devm_of_phy_provider_register(phy->dev,
 			of_phy_simple_xlate);
-	if (IS_ERR(phy_provider))
+	if (IS_ERR(phy_provider)) {
+		pm_runtime_disable(phy->dev);
 		return PTR_ERR(phy_provider);
+	}
 
 	phy->wkupclk = devm_clk_get(phy->dev, "wkupclk");
 	if (IS_ERR(phy->wkupclk)) {
-- 
1.8.3.2