[PATCH v3 2/4] usb: host: xhci-plat: Get PHYs for xhci's hcds

[Vivek Gautam <gautam.vivek@samsung.com>]

The host controller by itself may sometimes need to handle PHY
and/or calibrate some of the PHY settings to get full support out
of the PHY controller. The PHY core provides a calibration
funtionality now to do so.
Therefore, facilitate getting the two possible PHYs, viz.
USB 2.0 type (UTMI+) and USB 3.0 type (PIPE3).

Signed-off-by: Vivek Gautam <gautam.vivek@samsung.com>
---
 drivers/usb/host/xhci-plat.c |   17 +++++++++++++++++
 1 file changed, 17 insertions(+)

diff --git a/drivers/usb/host/xhci-plat.c b/drivers/usb/host/xhci-plat.c
index 1a0cf9f..d097d60 100644
--- a/drivers/usb/host/xhci-plat.c
+++ b/drivers/usb/host/xhci-plat.c
@@ -16,6 +16,7 @@
 #include <linux/module.h>
 #include <linux/of.h>
 #include <linux/platform_device.h>
+#include <linux/phy/phy.h>
 #include <linux/slab.h>
 #include <linux/usb/xhci_pdriver.h>
 
@@ -180,6 +181,14 @@ static int xhci_plat_probe(struct platform_device *pdev)
 			goto put_hcd;
 	}
 
+	/* Get possile USB 2.0 type PHY (UTMI+) available with xhci */
+	hcd->gen_phy = devm_phy_get(&pdev->dev, "usb2-phy");
+	if (IS_ERR(hcd->gen_phy)) {
+		ret = PTR_ERR(hcd->gen_phy);
+		if (ret != -ENOSYS && ret != -ENODEV)
+			dev_dbg(&pdev->dev, "no usb2 phy configured\n");
+	}
+
 	ret = usb_add_hcd(hcd, irq, IRQF_SHARED);
 	if (ret)
 		goto disable_clk;
@@ -209,6 +218,14 @@ static int xhci_plat_probe(struct platform_device *pdev)
 	if (HCC_MAX_PSA(xhci->hcc_params) >= 4)
 		xhci->shared_hcd->can_do_streams = 1;
 
+	/* Get possile USB 3.0 type PHY (PIPE3) available with xhci */
+	xhci->shared_hcd->gen_phy = devm_phy_get(&pdev->dev, "usb3-phy");
+	if (IS_ERR(xhci->shared_hcd->gen_phy)) {
+		ret = PTR_ERR(xhci->shared_hcd->gen_phy);
+		if (ret != -ENOSYS && ret != -ENODEV)
+			dev_dbg(&pdev->dev, "no usb3 phy configured\n");
+	}
+
 	ret = usb_add_hcd(xhci->shared_hcd, irq, IRQF_SHARED);
 	if (ret)
 		goto put_usb3_hcd;
-- 
1.7.10.4