[PATCH 2/4] tty: omap-serial: prevent division by zero

[Frans Klaver <frans.klaver@xsens.com>]

If the chosen baud rate is large enough (e.g. 3.5 megabaud), the
calculated n values in calculate_baud_abs_diff may become 0. This causes
a division by zero when calculating the difference between calculated
and desired baud rates. To prevent this, cap n on 1.

Signed-off-by: Frans Klaver <frans.klaver@xsens.com>
---
 drivers/tty/serial/omap-serial.c | 6 +++++-
 1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/drivers/tty/serial/omap-serial.c b/drivers/tty/serial/omap-serial.c
index ae935ce..14a0167 100644
--- a/drivers/tty/serial/omap-serial.c
+++ b/drivers/tty/serial/omap-serial.c
@@ -246,8 +246,12 @@ static inline int calculate_baud_abs_diff(struct uart_port *port,
 				unsigned int baud, unsigned int mode)
 {
 	unsigned int n = port->uartclk / (mode * baud);
-	int abs_diff = baud - (port->uartclk / (mode * n));
+	int abs_diff;
 
+	if (n == 0)
+		n = 1;
+
+	abs_diff = baud - (uartclk / (mode * n));
 	if (abs_diff < 0)
 		abs_diff = -abs_diff;
 
-- 
1.9.3