[PATCH 2/3] Documentation: dt: input: tsc2007: Document new parameters

[Marek Belisko <marek@goldelico.com>]

Signed-off-by: Marek Belisko <marek@goldelico.com>
---
 .../devicetree/bindings/input/touchscreen/tsc2007.txt   | 17 ++++++++++++++---
 1 file changed, 14 insertions(+), 3 deletions(-)

diff --git a/Documentation/devicetree/bindings/input/touchscreen/tsc2007.txt b/Documentation/devicetree/bindings/input/touchscreen/tsc2007.txt
index ec365e1..46b086c 100644
--- a/Documentation/devicetree/bindings/input/touchscreen/tsc2007.txt
+++ b/Documentation/devicetree/bindings/input/touchscreen/tsc2007.txt
@@ -13,14 +13,25 @@ Optional properties:
   (see interrupt binding[0]).
 - interrupts: (gpio) interrupt to which the chip is connected
   (see interrupt binding[0]).
-- ti,max-rt: maximum pressure.
+- ti,swap-xy: if present, swap x and y values. Rotation left/right is
+  achieved by combination with flipping of x or y.
+- ti,min-x: minimum x (default 0). Use this for a coarse calibration of the
+  touch if there is no user space option (e.g. Android, X11).
+- ti,max-x: maximum x (default 4095). If max-x is smaller than min-x the
+  axis is swapped.
+- ti,min-y: minimum y (default 0).
+- ti,max-y: maximum y (default 4095).
+- ti,min-rt: minimum pressure (default 0).
+- ti,max-rt: maximum pressure (default 4095). Depending on your needs, you
+  can also invert the pressure value since the raw rt value  reports the
+  resistance and not the "pressure" (i.e. becomes lower for higher pressure).
 - ti,fuzzx: specifies the absolute input fuzz x value.
   If set, it will permit noise in the data up to +- the value given to the fuzz
-  parameter, that is used to filter noise from the event stream.
+  parameter, that is used to filter noise from the event stream (default 0).
 - ti,fuzzy: specifies the absolute input fuzz y value.
 - ti,fuzzz: specifies the absolute input fuzz z value.
 - ti,poll-period: how much time to wait (in milliseconds) before reading again the
-  values from the tsc2007.
+  values from the tsc2007 (default 1).
 
 [0]: Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
 [1]: Documentation/devicetree/bindings/gpio/gpio.txt
-- 
1.9.3