From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1752626AbaKGNB6 (ORCPT ); Fri, 7 Nov 2014 08:01:58 -0500 Received: from bhuna.collabora.co.uk ([93.93.135.160]:44216 "EHLO bhuna.collabora.co.uk" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1752114AbaKGNA0 (ORCPT ); Fri, 7 Nov 2014 08:00:26 -0500 From: Javier Martinez Canillas To: Mark Brown Cc: Kukjin Kim , Chanwoo Choi , Olof Johansson , Chris Zhong , Krzysztof Kozlowski , Abhilash Kesavan , linux-samsung-soc@vger.kernel.org, linux-kernel@vger.kernel.org, devicetree@vger.kernel.org, Javier Martinez Canillas Subject: [PATCH v5 1/5] regulator: Document binding for initial and suspend modes Date: Fri, 7 Nov 2014 14:00:01 +0100 Message-Id: <1415365205-27630-2-git-send-email-javier.martinez@collabora.co.uk> X-Mailer: git-send-email 2.1.0 In-Reply-To: <1415365205-27630-1-git-send-email-javier.martinez@collabora.co.uk> References: <1415365205-27630-1-git-send-email-javier.martinez@collabora.co.uk> Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Some regulators can run on different operating modes (opmodes). This allows systems to choose the most efficient opmode for each regulator. This patch builds on top of (291d761 regulator: Document binding for regulator suspend state for PM state) adding a regulator-initial-mode DT property to configure at startup the operating mode for regulators that support changing its mode during normal operation and a property regulator-mode to be used in the regulator-state-[mem/disk] nodes for regulators that supports changing its operating mode when the system enters in a suspend state. The set of possible modes that a regulator can operate depends on the hardware capabilities so a list of generic operating modes can't be provided. Instead, each hardware binding should define the list of valid operating modes for the regulators found on that device. Signed-off-by: Javier Martinez Canillas --- Changes in v5: None Changes in v4: None Changes in v3: - Rebased on top of regulator suspend voltage series Documentation/devicetree/bindings/regulator/regulator.txt | 14 ++++++++++++++ 1 file changed, 14 insertions(+) diff --git a/Documentation/devicetree/bindings/regulator/regulator.txt b/Documentation/devicetree/bindings/regulator/regulator.txt index 4e7ed76..3fffa3b 100644 --- a/Documentation/devicetree/bindings/regulator/regulator.txt +++ b/Documentation/devicetree/bindings/regulator/regulator.txt @@ -30,6 +30,20 @@ Optional properties: - regulator-off-in-suspend: regulator should be off in suspend state. - regulator-suspend-microvolt: regulator should be set to this voltage in suspend. + - regulator-mode: operating mode in the given suspend state. + The set of possible operating modes depends on the capabilities of + every hardware so the valid modes are documented on each regulator + device tree binding document. + The "regulator-mode" property only takes effect if the regulator is + enabled for the given suspend state using "regulator-on-in-suspend". + If the regulator has not been explicitly disabled for the given state + with "regulator-off-in-suspend", then setting the operating mode + will also have no effect. +- regulator-initial-mode: initial operating mode. The set of possible operating + modes is the same used for the regulator-mode property and the device binding + documentation explains which property each regulator supports. +If no mode is defined, then the OS will not manage the modes and the hardware +default values will be used instead. Deprecated properties: - regulator-compatible: If a regulator chip contains multiple -- 2.1.0