From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1752464AbaLSJgX (ORCPT ); Fri, 19 Dec 2014 04:36:23 -0500 Received: from mail-wi0-f175.google.com ([209.85.212.175]:45703 "EHLO mail-wi0-f175.google.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1752438AbaLSJgR (ORCPT ); Fri, 19 Dec 2014 04:36:17 -0500 From: Bartosz Golaszewski To: Guenter Roeck Cc: LKML , Benoit Cousson , Patrick Titiano , LM Sensors , Bartosz Golaszewski Subject: [RESEND PATCH v7 0/5] hwmon: ina2xx: implement chip reinitialization and add new attributes Date: Fri, 19 Dec 2014 10:36:04 +0100 Message-Id: <1418981769-11287-1-git-send-email-bgolaszewski@baylibre.com> X-Mailer: git-send-email 2.1.3 Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org This series implements a mechanism to detect if the chip is in its POR state and reinitialize it if needed. It also extends the sysfs interface to make the driver configurable at run-time. The shunt_resistor attribute allows to change the shunt resistance value at run-time in cases where ina2xx used to do the measurement isn't integrated with the shunt. The avg_rate attribute allows to increase/decrease noise reduction. v7: - implemented a retry counter for the reinitialization procedure - using msleep() (since the sleep is > 20ms) instead of mdelay() when waiting for the chip update v6: https://www.mail-archive.com/linux-kernel%40vger.kernel.org/msg787390.html Bartosz Golaszewski (5): hwmon: ina2xx: reinitialize the chip in case it's been reset hwmon: ina2xx: remove a stray new line hwmon: ina2xx: don't accept shunt values greater than the calibration factor hwmon: ina2xx: make shunt resistance configurable at run-time hwmon: ina2xx: allow to change the averaging rate at run-time Documentation/hwmon/ina2xx | 8 +- drivers/hwmon/ina2xx.c | 304 +++++++++++++++++++++++++++++++++++++++------ 2 files changed, 269 insertions(+), 43 deletions(-) -- 2.1.3