From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1752363AbbLCSCU (ORCPT ); Thu, 3 Dec 2015 13:02:20 -0500 Received: from lists.s-osg.org ([54.187.51.154]:56487 "EHLO lists.s-osg.org" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1751441AbbLCSCS (ORCPT ); Thu, 3 Dec 2015 13:02:18 -0500 From: Javier Martinez Canillas To: linux-kernel@vger.kernel.org Cc: devicetree@vger.kernel.org, linux-omap@vger.kernel.org, Tony Lindgren , linux-arm-kernel@lists.infradead.org, Enric Balletbo i Serra , Javier Martinez Canillas Subject: [PATCH 0/2] ARM: dts: Use MMC pwrseq instead regulators for IGEP WiFi init Date: Thu, 3 Dec 2015 15:02:07 -0300 Message-Id: <1449165729-993-1-git-send-email-javier@osg.samsung.com> X-Mailer: git-send-email 2.4.3 Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Hello, This series converts the IGEPv2 (IGEP0020) and IGEP COM Module (IGEP0030) Device Tree to use the MMC power sequence provider to initialize the SDIO WiFi chip instead of using fake fixed regulators to just toggle the Reset and Power pins in the chip. The patches were tested on an DM3730 IGEPv2 board but the IGEP COM Module is the same with regard to the SDIO WiFi so it should be safe to land too. The IGEPv2 Rev.F and the IGEP COM Module Rev.G DTS were not converted due using a different WiFi chip (wlcore instead of libertas) than the one in the board I've access to test so I preferred to leave those untouched. Best regards, Javier Javier Martinez Canillas (2): ARM: dts: omap3-igep0020: Use MMC pwrseq to init SDIO WiFi ARM: dts: omap3-igep0030: Use MMC pwrseq to init SDIO WiFi arch/arm/boot/dts/omap3-igep0020.dts | 24 ++++++++---------------- arch/arm/boot/dts/omap3-igep0030.dts | 24 ++++++++---------------- 2 files changed, 16 insertions(+), 32 deletions(-) -- 2.4.3