[PATCH v6 2/8] spi: imx: enable loopback only for ECSPI controller family

[Anton Bondarenko <anton.bondarenko.sama@gmail.com>]

Limit SPI_LOOP mode to ECSPI controller (iMX.51, iMX53 and i.MX6) only since
there is no support in other families specific code for now.

Signed-off-by: Anton Bondarenko <anton.bondarenko.sama@gmail.com>
---
 drivers/spi/spi-imx.c | 11 ++++++-----
 1 file changed, 6 insertions(+), 5 deletions(-)

diff --git a/drivers/spi/spi-imx.c b/drivers/spi/spi-imx.c
index 3aa33c8..17a90dc 100644
--- a/drivers/spi/spi-imx.c
+++ b/drivers/spi/spi-imx.c
@@ -1140,6 +1140,9 @@ static int spi_imx_probe(struct platform_device *pdev)
 	spi_imx = spi_master_get_devdata(master);
 	spi_imx->bitbang.master = master;
 
+	spi_imx->devtype_data = of_id ? of_id->data :
+		(struct spi_imx_devtype_data *)pdev->id_entry->driver_data;
+
 	for (i = 0; i < master->num_chipselect; i++) {
 		int cs_gpio = of_get_named_gpio(np, "cs-gpios", i);
 		if (!gpio_is_valid(cs_gpio) && mxc_platform_info)
@@ -1164,14 +1167,12 @@ static int spi_imx_probe(struct platform_device *pdev)
 	spi_imx->bitbang.master->cleanup = spi_imx_cleanup;
 	spi_imx->bitbang.master->prepare_message = spi_imx_prepare_message;
 	spi_imx->bitbang.master->unprepare_message = spi_imx_unprepare_message;
-	spi_imx->bitbang.master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_CS_HIGH |
-					     SPI_LOOP;
+	spi_imx->bitbang.master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_CS_HIGH;
+	if (is_imx51_ecspi(spi_imx))
+		spi_imx->bitbang.master->mode_bits |= SPI_LOOP;
 
 	init_completion(&spi_imx->xfer_done);
 
-	spi_imx->devtype_data = of_id ? of_id->data :
-		(struct spi_imx_devtype_data *) pdev->id_entry->driver_data;
-
 	res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
 	spi_imx->base = devm_ioremap_resource(&pdev->dev, res);
 	if (IS_ERR(spi_imx->base)) {
-- 
2.6.3