[PATCH] lightnvm: do not load L2P table if not supported

["Javier González" <jg@lightnvm.io>]

An Open-Channel SSD can work on two modes: (i) hybrid mode, where the
L2P table is maintained both by the host and by the device; and (ii)
full host-based, where the L2P table is uniquely maintained by the host.
The current rrpc target operates on hybrid mode.

In the advent of a new target implementing the full host-based mode, do
not assume that the L2P table must be loaded on the generic media
manager; check device properties loaded on the identify command instead.

Signed-off-by: Javier González <javier@cnexlabs.com>
---
 drivers/lightnvm/gennvm.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/lightnvm/gennvm.c b/drivers/lightnvm/gennvm.c
index 42c1c2a..0625d42 100644
--- a/drivers/lightnvm/gennvm.c
+++ b/drivers/lightnvm/gennvm.c
@@ -257,6 +257,9 @@ static int gennvm_blocks_init(struct nvm_dev *dev, struct gen_nvm *gn)
 		}
 	}
 
+	if (!(dev->identity.dom & NVM_RSP_L2P))
+		return 0;
+
 	if (dev->ops->get_l2p_tbl) {
 		ret = dev->ops->get_l2p_tbl(dev, 0, dev->total_secs,
 							gennvm_block_map, dev);
-- 
2.5.0