Re: problem accessing /dev/port

[Paul Mackerras <paulus@samba.org>]

Christopher Friesen writes:

> To begin, I'm running 2.2.17 with some patches.
> 
> I'm attempting to have a userspace app read and write I/O ports on a powerpc
> machine.  The obvious method (iopl()) doesn't seem to be available (using glibc,
> but sys/io.h doesn't exist).
> 
> When I try and access /dev/port with a small utility that works fine on my PIII,
> I get the error message "Device not configured".  The file exists in /dev and
> has the same permissions on both machines.

If you look in drivers/char/mem.c you will see an #if that eliminates
the statement filp->f_op = &port_fops if CONFIG_PPC is defined.  The
reason for this is that accessing a non-existent I/O port on powermacs
generates a machine check interrupt which, in 2.2.x kernels, causes a
panic.  The situation is better in 2.4 because we catch the machine
check and arrange for inb/w/l to return ~0.

> Do I need to enable something in the kernel to support this?  Where is this
> configured?

Change the #if line to take out the defined(CONFIG_PPC) part.

The other way to access I/O from userspace is to mmap /dev/mem at the
offset that corresponds to the physical address where your PCI host
bridge maps PCI I/O space, e.g. you would use an offset of 0xfe000000
for an MPC106 (grackle) bridge.  Once again the situation is better in
2.4 since you can mmap the /proc/bus/pci/bb/dd.f file corresponding to
your pci device and access its memory and I/O regions that way.

Paul.