[PATCH V2 1/3] dt-bindings: mmc: tegra: Add pinctrl for pad drive strength config

[Sowjanya Komatineni <skomatineni@nvidia.com>]

Add pinctrl for 3V3 and 1V8 pad drive strength configuration for
Tegra210 sdmmc which has pad configuration registers in the pinmux
reigster domain.

Signed-off-by: Sowjanya Komatineni <skomatineni@nvidia.com>
---
 Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt | 6 +++++-
 1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt b/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt
index 32b4b4e41923..2cecdc71d94c 100644
--- a/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt
+++ b/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt
@@ -39,12 +39,16 @@ sdhci@c8000200 {
 	bus-width = <8>;
 };
 
-Optional properties for Tegra210 and Tegra186:
+Optional properties for Tegra210, Tegra186 and Tegra194:
 - pinctrl-names, pinctrl-0, pinctrl-1 : Specify pad voltage
   configurations. Valid pinctrl-names are "sdmmc-3v3" and "sdmmc-1v8"
   for controllers supporting multiple voltage levels. The order of names
   should correspond to the pin configuration states in pinctrl-0 and
   pinctrl-1.
+- pinctrl-names : "sdmmc-3v3-drv" and "sdmmc-1v8-drv" are applicable for
+  Tegra210 where pad config registers are in the pinmux register domain
+  for pull-up-strength and pull-down-strength values configuration when
+  using pads at 3V3 and 1V8 levels.
 - nvidia,only-1-8-v : The presence of this property indicates that the
   controller operates at a 1.8 V fixed I/O voltage.
 - nvidia,pad-autocal-pull-up-offset-3v3,
-- 
2.7.4