Re: [RFC v2 4/5] arm64: dts: imx8mq: Add nodes for PCIe IP blocks

[Lucas Stach <l.stach@pengutronix.de>]

Am Donnerstag, den 07.02.2019, 16:29 -0800 schrieb Andrey Smirnov:
> Add nodes for two PCIe controllers found on i.MX8MQ.
> 
> > Signed-off-by: Andrey Smirnov <andrew.smirnov@gmail.com>
> > Cc: Shawn Guo <shawnguo@kernel.org>
> > Cc: Fabio Estevam <fabio.estevam@nxp.com>
> > Cc: Chris Healy <cphealy@gmail.com>
> > Cc: Lucas Stach <l.stach@pengutronix.de>
> > Cc: Leonard Crestez <leonard.crestez@nxp.com>
> > Cc: "A.s. Dong" <aisheng.dong@nxp.com>
> > Cc: Richard Zhu <hongxing.zhu@nxp.com>
> Cc: linux-imx@nxp.com
> Cc: linux-arm-kernel@lists.infradead.org
> Cc: linux-kernel@vger.kernel.org

One minor thing below, otherwise:

Reviewed-by: Lucas Stach <l.stach@pengutronix.de>

> ---
>  arch/arm64/boot/dts/freescale/imx8mq.dtsi | 58 +++++++++++++++++++++++
>  1 file changed, 58 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/freescale/imx8mq.dtsi b/arch/arm64/boot/dts/freescale/imx8mq.dtsi
> index 89babc531380..8ceab748ed04 100644
> --- a/arch/arm64/boot/dts/freescale/imx8mq.dtsi
> +++ b/arch/arm64/boot/dts/freescale/imx8mq.dtsi
> @@ -6,6 +6,7 @@
>  
>  #include <dt-bindings/clock/imx8mq-clock.h>
>  #include <dt-bindings/power/imx8mq-power.h>
> +#include <dt-bindings/reset/imx8mq-reset.h>
>  #include <dt-bindings/gpio/gpio.h>
>  #include <dt-bindings/interrupt-controller/arm-gic.h>
>  #include "imx8mq-pinfunc.h"
> @@ -539,6 +540,63 @@
> >  			};
> >  		};
>  
> > > +		pcie0: pcie@33800000 {
> > +			compatible = "fsl,imx8mq-pcie";
> > +			reg = <0x33800000 0x400000>,
> > +			      <0x1ff00000 0x80000>;
> > +			reg-names = "dbi", "config";
> > +			#address-cells = <3>;
> > +			#size-cells = <2>;
> > +			device_type = "pci";
> > +			bus-range = <0x00 0xff>;
> > +			ranges = <0x81000000 0 0x00000000 0x1ff80000 0 0x00010000 /* downstream I/O 64KB */
> > +			          0x82000000 0 0x18000000 0x18000000 0 0x07f00000>; /* non-prefetchable memory */
> > +			num-lanes = <1>;
> > +			interrupts = <GIC_SPI 122 IRQ_TYPE_LEVEL_HIGH>;
> > +			interrupt-names = "msi";
> > +			#interrupt-cells = <1>;
> > +			interrupt-map-mask = <0 0 0 0x7>;
> > +			interrupt-map = <0 0 0 1 &gic GIC_SPI 125 IRQ_TYPE_LEVEL_HIGH>,
> > +			                <0 0 0 2 &gic GIC_SPI 124 IRQ_TYPE_LEVEL_HIGH>,
> > +			                <0 0 0 3 &gic GIC_SPI 123 IRQ_TYPE_LEVEL_HIGH>,
> > +			                <0 0 0 4 &gic GIC_SPI 122 IRQ_TYPE_LEVEL_HIGH>;
> > +			fsl,max-link-speed = <2>;
> > +			power-domains = <&pgc_pcie>;
> > +			resets = <&src IMX8MQ_RESET_PCIEPHY>,
> > +			         <&src IMX8MQ_RESET_PCIE_CTRL_APPS_EN>,
> > +			         <&src IMX8MQ_RESET_PCIE_CTRL_APPS_TURNOFF>;
> > +			reset-names = "pciephy", "apps", "turnoff";
> > +			status = "disabled";
> > +		};
> +
> +		pcie1: pcie@0x33c00000 {
                            ^
Node name should not have the hex prefix in the address.

> +			compatible = "fsl,imx8mq-pcie";
> > +			reg = <0x33c00000 0x400000>,
> > +			      <0x27f00000 0x80000>;
> > +			reg-names = "dbi", "config";
> > +			#address-cells = <3>;
> > +			#size-cells = <2>;
> > +			device_type = "pci";
> > +			ranges =  <0x81000000 0 0x00000000 0x27f80000 0 0x00010000 /* downstream I/O 64KB */
> > +				   0x82000000 0 0x20000000 0x20000000 0 0x07f00000>; /* non-prefetchable memory */
> > +			num-lanes = <1>;
> > +			interrupts = <GIC_SPI 74 IRQ_TYPE_LEVEL_HIGH>;
> > +			interrupt-names = "msi";
> > +			#interrupt-cells = <1>;
> > +			interrupt-map-mask = <0 0 0 0x7>;
> > +			interrupt-map = <0 0 0 1 &gic GIC_SPI 77 IRQ_TYPE_LEVEL_HIGH>,
> > +					<0 0 0 2 &gic GIC_SPI 76 IRQ_TYPE_LEVEL_HIGH>,
> > +					<0 0 0 3 &gic GIC_SPI 75 IRQ_TYPE_LEVEL_HIGH>,
> > +					<0 0 0 4 &gic GIC_SPI 74 IRQ_TYPE_LEVEL_HIGH>;
> > +			fsl,max-link-speed = <2>;
> > +			power-domains = <&pgc_pcie>;
> > +			resets = <&src IMX8MQ_RESET_PCIEPHY2>,
> > +			         <&src IMX8MQ_RESET_PCIE2_CTRL_APPS_EN>,
> > +			         <&src IMX8MQ_RESET_PCIE2_CTRL_APPS_TURNOFF>;
> > +			reset-names = "pciephy", "apps", "turnoff";
> > +			status = "disabled";
> > +		};
> +
> > >  		gic: interrupt-controller@38800000 {
> >  			compatible = "arm,gic-v3";
> > >  			reg = <0x38800000 0x10000>,	/* GIC Dist */