Re: [PATCH v7 2/3] drm/msm/dpu: allow using two SSPP blocks for a single plane

[Abhinav Kumar <quic_abhinavk@quicinc.com>]

On 11/29/2024 5:55 PM, Dmitry Baryshkov wrote:
> Virtual wide planes give high amount of flexibility, but it is not
> always enough:
> 
> In parallel multirect case only the half of the usual width is supported
> for tiled formats. Thus the whole width of two tiled multirect
> rectangles can not be greater than max_linewidth, which is not enough
> for some platforms/compositors.
> 
> Another example is as simple as wide YUV plane. YUV planes can not use
> multirect, so currently they are limited to max_linewidth too.
> 
> Now that the planes are fully virtualized, add support for allocating
> two SSPP blocks to drive a single DRM plane. This fixes both mentioned
> cases and allows all planes to go up to 2*max_linewidth (at the cost of
> making some of the planes unavailable to the user).
> 

Overall looks so much cleaner after unification!

One small nit below,


You can still have,

Reviewed-by: Abhinav Kumar <quic_abhinavk@quicinc.com>

Note: we have started testing this series with sc7180 CrOS, and will 
report our findings/ give tested-by this week.


<snip>

> +static bool dpu_plane_try_multirect_parallel(struct dpu_sw_pipe *pipe, struct dpu_sw_pipe_cfg *pipe_cfg,
> +					     struct dpu_sw_pipe *r_pipe, struct dpu_sw_pipe_cfg *r_pipe_cfg,
> +					     struct dpu_hw_sspp *sspp, const struct msm_format *fmt,
> +					     uint32_t max_linewidth)
> +{
> +	r_pipe->sspp = NULL;
> +
> +	pipe->multirect_index = DPU_SSPP_RECT_SOLO;
> +	pipe->multirect_mode = DPU_SSPP_MULTIRECT_NONE;
> +
> +	r_pipe->multirect_index = DPU_SSPP_RECT_SOLO;
> +	r_pipe->multirect_mode = DPU_SSPP_MULTIRECT_NONE;
> +


There are two places where the multirect_index and multirect_mode are 
reset. Would it be better to just have a small api 
dpu_plane_reset_multirect() and do this there?