[PATCH] spi: spi-zynq-qspi: Fix some wrong goto jumps & missing error code

[zpershuai <zpershuai@gmail.com>]

In zynq_qspi_probe function, when enable the device clock is done,
the return of all the functions should goto the clk_dis_all label.

If num_cs is not right then this should return a negative error
code but currently it returns success.

Signed-off-by: zpershuai <zpershuai@gmail.com>
---
 drivers/spi/spi-zynq-qspi.c | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/drivers/spi/spi-zynq-qspi.c b/drivers/spi/spi-zynq-qspi.c
index 5a3d81c31d04..9262c6418463 100644
--- a/drivers/spi/spi-zynq-qspi.c
+++ b/drivers/spi/spi-zynq-qspi.c
@@ -678,14 +678,14 @@ static int zynq_qspi_probe(struct platform_device *pdev)
 	xqspi->irq = platform_get_irq(pdev, 0);
 	if (xqspi->irq <= 0) {
 		ret = -ENXIO;
-		goto remove_master;
+		goto clk_dis_all;
 	}
 	ret = devm_request_irq(&pdev->dev, xqspi->irq, zynq_qspi_irq,
 			       0, pdev->name, xqspi);
 	if (ret != 0) {
 		ret = -ENXIO;
 		dev_err(&pdev->dev, "request_irq failed\n");
-		goto remove_master;
+		goto clk_dis_all;
 	}
 
 	ret = of_property_read_u32(np, "num-cs",
@@ -693,8 +693,9 @@ static int zynq_qspi_probe(struct platform_device *pdev)
 	if (ret < 0) {
 		ctlr->num_chipselect = 1;
 	} else if (num_cs > ZYNQ_QSPI_MAX_NUM_CS) {
+		ret = -EINVAL;
 		dev_err(&pdev->dev, "only 2 chip selects are available\n");
-		goto remove_master;
+		goto clk_dis_all;
 	} else {
 		ctlr->num_chipselect = num_cs;
 	}
-- 
2.17.1