From: Rob Herring <robh@kernel.org>
To: Chris Packham <chris.packham@alliedtelesis.co.nz>
Cc: linux-mtd@lists.infradead.org, linux-kernel@vger.kernel.org,
robh+dt@kernel.org, vigneshr@ti.com, miquel.raynal@bootlin.com,
krzysztof.kozlowski+dt@linaro.org, richard@nod.at,
Vadym Kochan <vadym.kochan@plvision.eu>,
linux-arm-kernel@lists.infradead.org,
gregory.clement@bootlin.com, andrew@lunn.ch,
sebastian.hesselbarth@gmail.com, devicetree@vger.kernel.org
Subject: Re: [PATCH v9 3/3] dt-bindings: mtd: marvell-nand: Convert to YAML DT scheme
Date: Wed, 14 Jun 2023 23:25:53 -0600 [thread overview]
Message-ID: <168680675314.3823167.2320130564713925420.robh@kernel.org> (raw)
In-Reply-To: <20230615040447.3484564-4-chris.packham@alliedtelesis.co.nz>
On Thu, 15 Jun 2023 16:04:47 +1200, Chris Packham wrote:
> From: Vadym Kochan <vadym.kochan@plvision.eu>
>
> Switch the DT binding to a YAML schema to enable the DT validation.
>
> The text binding didn't mention it as a requirement but existing usage
> has
>
> compatible = "marvell,armada-8k-nand-controller",
> "marvell,armada370-nand-controller";
>
> so the YAML allows this in addition to the individual compatible values.
>
> There was also an incorrect reference to dma-names being "rxtx" where
> the driver and existing device trees actually use dma-names = "data" so
> this is corrected in the conversion.
>
> Signed-off-by: Vadym Kochan <vadym.kochan@plvision.eu>
> Signed-off-by: Chris Packham <chris.packham@alliedtelesis.co.nz>
> ---
>
> Notes:
> Changes in v9:
> - depend on series from Miquel
> https://lore.kernel.org/linux-mtd/20230606175246.190465-1-miquel.raynal@bootlin.com/
> - enforce minimum/maximum for nand-rb
> - move required: block for controller
> - move unevaluatedProperties: for nand chip
> - remove label, partitions and nand-on-flash-bbt which are covered by
> generic schema
>
> Changes in v8:
> - Mark deprecated compatible values as such
> - Allow "marvell,armada-8k-nand-controller" without
> "marvell,armada370-nand-controller"
> - Make dma-names usage reflect reality
> - Update commit message
>
> Changes in v7:
> - Restore "label" and "partitions" properties (should be picked up via
> nand-controller.yaml but aren't)
> - Add/restore nand-on-flash-bbt and nand-ecc-mode which aren't covered
> by nand-controller.yaml.
> - Use "unevalautedProperties: false"
> - Corrections for clock-names, dma-names, nand-rb and nand-ecc-strength
> - Add pxa3xx-nand-controller example
>
> Changes in v6:
> - remove properties covered by nand-controller.yaml
> - add example using armada-8k compatible
>
> earlier changes:
>
> v5:
> 1) Get back "label" and "partitions" properties but without
> ref to the "partition.yaml" which was wrongly used.
>
> 2) Add "additionalProperties: false" for nand@ because all possible
> properties are described.
>
> v4:
> 1) Remove "label" and "partitions" properties
>
> 2) Use 2 clocks for A7K/8K platform which is a requirement
>
> v3:
> 1) Remove txt version from the MAINTAINERS list
>
> 2) Use enum for some of compatible strings
>
> 3) Drop:
> #address-cells
> #size-cells:
>
> as they are inherited from the nand-controller.yaml
>
> 4) Add restriction to use 2 clocks for A8K SoC
>
> 5) Dropped description for clock-names and extend it with
> minItems: 1
>
> 6) Drop description for "dmas"
>
> 7) Use "unevalautedProperties: false"
>
> 8) Drop quites from yaml refs.
>
> 9) Use 4-space indentation for the example section
>
> v2:
> 1) Fixed warning by yamllint with incorrect indentation for compatible list
>
> .../bindings/mtd/marvell,nand-controller.yaml | 218 ++++++++++++++++++
> .../devicetree/bindings/mtd/marvell-nand.txt | 126 ----------
> MAINTAINERS | 1 -
> 3 files changed, 218 insertions(+), 127 deletions(-)
> create mode 100644 Documentation/devicetree/bindings/mtd/marvell,nand-controller.yaml
> delete mode 100644 Documentation/devicetree/bindings/mtd/marvell-nand.txt
>
My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check'
on your patch (DT_CHECKER_FLAGS is new in v5.13):
yamllint warnings/errors:
dtschema/dtc warnings/errors:
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/mtd/marvell,nand-controller.yaml: Error in referenced schema matching $id: http://devicetree.org/schemas/mtd/raw-nand-chip.yaml
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/mtd/marvell,nand-controller.example.dtb: nand-controller@d0000: nand@0: False schema does not allow {'reg': [[0]], 'label': ['main-storage'], 'nand-rb': [[0]], 'nand-ecc-mode': ['hw'], 'marvell,nand-keep-config': True, 'nand-on-flash-bbt': True, 'nand-ecc-strength': [[4]], 'nand-ecc-step-size': [[512]], 'partitions': {'compatible': ['fixed-partitions'], '#address-cells': [[1]], '#size-cells': [[1]], 'partition@0': {'label': ['Rootfs'], 'reg': [[0, 1073741824]]}}}
from schema $id: http://devicetree.org/schemas/mtd/marvell,nand-controller.yaml#
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/mtd/marvell,nand-controller.example.dtb: nand-controller@d0000: nand@0: Unevaluated properties are not allowed ('label', 'nand-on-flash-bbt', 'partitions' were unexpected)
from schema $id: http://devicetree.org/schemas/mtd/marvell,nand-controller.yaml#
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/mtd/marvell,nand-controller.example.dtb: nand-controller@720000: nand@0: False schema does not allow {'reg': [[0]], 'label': ['main-storage'], 'nand-rb': [[0]], 'nand-ecc-mode': ['hw'], 'nand-ecc-strength': [[8]], 'nand-ecc-step-size': [[512]]}
from schema $id: http://devicetree.org/schemas/mtd/marvell,nand-controller.yaml#
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/mtd/marvell,nand-controller.example.dtb: nand-controller@720000: nand@0: Unevaluated properties are not allowed ('label' was unexpected)
from schema $id: http://devicetree.org/schemas/mtd/marvell,nand-controller.yaml#
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/mtd/marvell,nand-controller.example.dtb: nand-controller@43100000: nand@0: False schema does not allow {'reg': [[0]], 'nand-rb': [[0]], 'nand-ecc-mode': ['hw'], 'marvell,nand-keep-config': True}
from schema $id: http://devicetree.org/schemas/mtd/marvell,nand-controller.yaml#
doc reference errors (make refcheckdocs):
See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20230615040447.3484564-4-chris.packham@alliedtelesis.co.nz
The base for the series is generally the latest rc1. A different dependency
should be noted in *this* patch.
If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:
pip3 install dtschema --upgrade
Please check and re-submit after running the above command yourself. Note
that DT_SCHEMA_FILES can be set to your schema file to speed up checking
your schema. However, it must be unset to test all examples with your schema.
next prev parent reply other threads:[~2023-06-15 5:26 UTC|newest]
Thread overview: 13+ messages / expand[flat|nested] mbox.gz Atom feed top
2023-06-15 4:04 [PATCH v9 0/3] dt-bindings: mtd: marvell-nand: Add YAML scheme Chris Packham
2023-06-15 4:04 ` [PATCH v9 1/3] arm64: dts: marvell: cp11x: Fix nand_controller node name according to YAML Chris Packham
2023-06-16 11:55 ` Gregory CLEMENT
2023-06-15 4:04 ` [PATCH v9 2/3] ARM: dts: mvebu: align MTD partition nodes to dtschema Chris Packham
2023-06-16 11:56 ` Gregory CLEMENT
2023-06-15 4:04 ` [PATCH v9 3/3] dt-bindings: mtd: marvell-nand: Convert to YAML DT scheme Chris Packham
2023-06-15 5:25 ` Rob Herring [this message]
2023-06-15 7:45 ` Krzysztof Kozlowski
2023-06-15 21:06 ` Chris Packham
2023-06-16 8:15 ` Krzysztof Kozlowski
2023-06-16 8:24 ` Miquel Raynal
2023-06-16 8:38 ` Krzysztof Kozlowski
2023-06-16 8:44 ` Miquel Raynal
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=168680675314.3823167.2320130564713925420.robh@kernel.org \
--to=robh@kernel.org \
--cc=andrew@lunn.ch \
--cc=chris.packham@alliedtelesis.co.nz \
--cc=devicetree@vger.kernel.org \
--cc=gregory.clement@bootlin.com \
--cc=krzysztof.kozlowski+dt@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mtd@lists.infradead.org \
--cc=miquel.raynal@bootlin.com \
--cc=richard@nod.at \
--cc=robh+dt@kernel.org \
--cc=sebastian.hesselbarth@gmail.com \
--cc=vadym.kochan@plvision.eu \
--cc=vigneshr@ti.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®