[PATCH v1 1/2] dmaengine: dw-edma: Add fix to unmask the interrupt bit for HDMA

[Mrinmay Sarkar <quic_msarkar@quicinc.com>]

The current logic is enabling both STOP_INT_MASK and ABORT_INT_MASK
bit. This is apparently masking those particular interrupt rather than
unmasking the same.

This change will reset STOP_INT_MASK and ABORT_INT_MASK bit and unmask
these interrupts.

Signed-off-by: Mrinmay Sarkar <quic_msarkar@quicinc.com>
---
 drivers/dma/dw-edma/dw-hdma-v0-core.c | 9 +++++----
 1 file changed, 5 insertions(+), 4 deletions(-)

diff --git a/drivers/dma/dw-edma/dw-hdma-v0-core.c b/drivers/dma/dw-edma/dw-hdma-v0-core.c
index 10e8f07..88bd652f 100644
--- a/drivers/dma/dw-edma/dw-hdma-v0-core.c
+++ b/drivers/dma/dw-edma/dw-hdma-v0-core.c
@@ -247,10 +247,11 @@ static void dw_hdma_v0_core_start(struct dw_edma_chunk *chunk, bool first)
 	if (first) {
 		/* Enable engine */
 		SET_CH_32(dw, chan->dir, chan->id, ch_en, BIT(0));
-		/* Interrupt enable&unmask - done, abort */
-		tmp = GET_CH_32(dw, chan->dir, chan->id, int_setup) |
-		      HDMA_V0_STOP_INT_MASK | HDMA_V0_ABORT_INT_MASK |
-		      HDMA_V0_LOCAL_STOP_INT_EN | HDMA_V0_LOCAL_ABORT_INT_EN;
+		/* Interrupt unmask - done, abort */
+		tmp = GET_CH_32(dw, chan->dir, chan->id, int_setup) &
+		      ~HDMA_V0_STOP_INT_MASK & ~HDMA_V0_ABORT_INT_MASK;
+		/* Interrupt enable - done, abort */
+		tmp |= HDMA_V0_LOCAL_STOP_INT_EN | HDMA_V0_LOCAL_ABORT_INT_EN;
 		if (!(dw->chip->flags & DW_EDMA_CHIP_LOCAL))
 			tmp |= HDMA_V0_REMOTE_STOP_INT_EN | HDMA_V0_REMOTE_ABORT_INT_EN;
 		SET_CH_32(dw, chan->dir, chan->id, int_setup, tmp);
-- 
2.7.4