From: "Rob Herring (Arm)" <robh@kernel.org>
To: Junhao Xie <bigfoot@classfun.cn>
Cc: Krzysztof Kozlowski <krzk+dt@kernel.org>,
Jonas Karlman <jonas@kwiboo.se>,
linux-rockchip@lists.infradead.org,
linux-kernel@vger.kernel.org, FUKAUMI Naoki <naoki@radxa.com>,
Heiko Stuebner <heiko@sntech.de>,
devicetree@vger.kernel.org, Conor Dooley <conor+dt@kernel.org>,
linux-arm-kernel@lists.infradead.org,
Chukun Pan <amadeus@jmu.edu.cn>,
Dragan Simic <dsimic@manjaro.org>
Subject: Re: [PATCH v6 0/3] Add support for Ariaboard Photonicat RK3568
Date: Mon, 13 Jan 2025 09:26:02 -0600 [thread overview]
Message-ID: <173678159607.2153021.5826282359797453753.robh@kernel.org> (raw)
In-Reply-To: <20250112073344.1976411-1-bigfoot@classfun.cn>
On Sun, 12 Jan 2025 15:33:41 +0800, Junhao Xie wrote:
> Add dts for Ariaboard Photonicat RK3568.
>
> This series bring support for:
> * Debug UART
> * SDIO QCA9377 WiFi and Bluetooth
> * M.2 E-Key PCIe WiFi and Bluetooth
> * M.2 B-Key USB Modem WWAN
> * Ethernet WAN Port
> * MicroSD Card slot
> * eMMC
> * HDMI Output
> * Mali GPU
> * USB Type-A
>
> Changed from v1:
> - move some general nodes (firmware, ramoops, reboot-mode) to rk356x.dtsi
> - gmac1 change to phy-mode rgmii-id
> - corrected some regulator to be closer to schematics
> - rename rk3568-ariaboard-photonicat.dts to rk3568-photonicat.dts
> https://lore.kernel.org/lkml/20240904111456.87089-1-bigfoot@classfun.cn/
>
> Changed from v2:
> - remove unused headers
> - corrected some regulator to be closer to schematics
> - remove usb_host1_ohci, usb_host1_ehci, usb2phy1_host that have no connection
> https://lore.kernel.org/lkml/20240906045706.1004813-1-bigfoot@classfun.cn/
>
> Changed from v3:
> - corrected some regulator to be closer to schematics
> - changed to using clk32k_out1 in xin32k
> https://lore.kernel.org/lkml/20240911122809.1789778-2-bigfoot@classfun.cn/
>
> Changed from v4:
> - corrected some regulator to be closer to schematics
> - corrected some label to match node name
> - use resets props in phy node instead deprecated snps,reset-gpio
> https://lore.kernel.org/lkml/20240914145549.879936-1-bigfoot@classfun.cn/
>
> Changed from v5:
> - resort regulator nodes
> - remove dr_mode from usb_host1_xhci
> https://lore.kernel.org/lkml/20241108031847.700606-1-bigfoot@classfun.cn/
>
> Junhao Xie (3):
> dt-bindings: vendor-prefixes: Add prefix for Ariaboard
> dt-bindings: arm: rockchip: Add Ariaboard Photonicat RK3568
> arm64: dts: rockchip: add dts for Ariaboard Photonicat RK3568
>
> .../devicetree/bindings/arm/rockchip.yaml | 5 +
> .../devicetree/bindings/vendor-prefixes.yaml | 2 +
> arch/arm64/boot/dts/rockchip/Makefile | 1 +
> .../boot/dts/rockchip/rk3568-photonicat.dts | 599 ++++++++++++++++++
> 4 files changed, 607 insertions(+)
> create mode 100644 arch/arm64/boot/dts/rockchip/rk3568-photonicat.dts
>
> --
> 2.47.1
>
>
>
My bot found new DTB warnings on the .dts files added or changed in this
series.
Some warnings may be from an existing SoC .dtsi. Or perhaps the warnings
are fixed by another series. Ultimately, it is up to the platform
maintainer whether these warnings are acceptable or not. No need to reply
unless the platform maintainer has comments.
If you already ran DT checks and didn't see these error(s), then
make sure dt-schema is up to date:
pip3 install dtschema --upgrade
New warnings running 'make CHECK_DTBS=y for arch/arm64/boot/dts/rockchip/' for 20250112073344.1976411-1-bigfoot@classfun.cn:
arch/arm64/boot/dts/rockchip/rk3568-photonicat.dtb: bluetooth: 'clock-names' does not match any of the regexes: 'pinctrl-[0-9]+'
from schema $id: http://devicetree.org/schemas/net/bluetooth/qualcomm-bluetooth.yaml#
arch/arm64/boot/dts/rockchip/rk3568-photonicat.dtb: phy@fe8c0000: 'phy-supply' does not match any of the regexes: 'pinctrl-[0-9]+'
from schema $id: http://devicetree.org/schemas/phy/rockchip,pcie3-phy.yaml#
arch/arm64/boot/dts/rockchip/rk3568-photonicat.dtb: rfkill-modem: 'reset-gpios' does not match any of the regexes: 'pinctrl-[0-9]+'
from schema $id: http://devicetree.org/schemas/net/rfkill-gpio.yaml#
prev parent reply other threads:[~2025-01-13 15:26 UTC|newest]
Thread overview: 15+ messages / expand[flat|nested] mbox.gz Atom feed top
2025-01-12 7:33 Junhao Xie
2025-01-12 7:33 ` [PATCH v6 1/3] dt-bindings: vendor-prefixes: Add prefix for Ariaboard Junhao Xie
2025-01-12 7:33 ` [PATCH v6 2/3] dt-bindings: arm: rockchip: Add Ariaboard Photonicat RK3568 Junhao Xie
2025-01-12 7:33 ` [PATCH v6 3/3] arm64: dts: rockchip: add dts for " Junhao Xie
2025-01-12 8:20 ` Chukun Pan
2025-01-12 22:44 ` Junhao Xie
2025-01-12 8:47 ` Dragan Simic
2025-01-12 22:16 ` Junhao Xie
2025-01-13 4:25 ` Dragan Simic
2025-01-13 8:18 ` Junhao Xie
2025-01-13 8:24 ` Dragan Simic
2025-01-12 8:50 ` [PATCH v6 0/3] Add support " Dragan Simic
2025-01-12 22:27 ` Junhao Xie
2025-01-13 4:30 ` Dragan Simic
2025-01-13 15:26 ` Rob Herring (Arm) [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=173678159607.2153021.5826282359797453753.robh@kernel.org \
--to=robh@kernel.org \
--cc=amadeus@jmu.edu.cn \
--cc=bigfoot@classfun.cn \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=dsimic@manjaro.org \
--cc=heiko@sntech.de \
--cc=jonas@kwiboo.se \
--cc=krzk+dt@kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-rockchip@lists.infradead.org \
--cc=naoki@radxa.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®