Re: [PATCH v13 1/5] dt-bindings: gpio: fix microchip,mpfs-gpio interrupt documentation

["Rob Herring (Arm)" <robh@kernel.org>]

On Wed, 18 Mar 2026 11:04:32 +0000, Conor Dooley wrote:
> From: Conor Dooley <conor.dooley@microchip.com>
> 
> The microchip,mpfs-gpio binding suffered greatly due to being written
> with a narrow minded view of the controller, and the interrupt bits
> ended up incorrect. It was mistakenly assumed that the interrupt
> configuration was set by platform firmware, based on the FPGA
> configuration, and that the GPIO DT nodes were the only way to really
> communicate interrupt configuration to software.
> 
> Instead, the mux should be a device in its own right, and the GPIO
> controllers should be connected to it, rather than to the PLIC.
> Now that a binding exists for that mux, try to fix the misconceptions
> in the GPIO controller binding.
> 
> Firstly, it's not possible for this controller to have fewer than 14
> GPIOs, and thus 14 interrupts also. There are three controllers, with
> 14, 24 & 32 GPIOs each. The fabric core, CoreGPIO, can of course have
> a customisable number of GPIOs.
> 
> The example is wacky too - it follows from the incorrect understanding
> that the GPIO controllers are connected to the PLIC directly. They are
> not however, with a mux sitting in between. Update the example to use
> the mux as a parent, and the interrupt numbers at the mux for GPIO2 as
> the example - rather than the strange looking, repeated <53>.
> 
> Signed-off-by: Conor Dooley <conor.dooley@microchip.com>
> ---
>  .../bindings/gpio/microchip,mpfs-gpio.yaml    | 24 ++++++++++++-------
>  1 file changed, 15 insertions(+), 9 deletions(-)
> 

Acked-by: Rob Herring (Arm) <robh@kernel.org>