Re: [PATCH v1 1/7] dt-bindings: i2c: qcom,i2c-geni: Document DT properties for QUP firmware loading

[Viken Dadhaniya <quic_vdadhani@quicinc.com>]

On 12/5/2024 4:06 AM, Dmitry Baryshkov wrote:
> On Wed, Dec 04, 2024 at 08:33:20PM +0530, Viken Dadhaniya wrote:
>> Document the 'qcom,load-firmware' and 'qcom,xfer-mode' properties to
>> support SE(Serial Engine) firmware loading from the protocol driver and to
>> select the data transfer mode, either GPI DMA (Generic Packet Interface)
>> or non-GPI mode (PIO/CPU DMA).
>>
>> I2C controller can operate in one of two modes based on the
>> 'qcom,xfer-mode' property, and the firmware is loaded accordingly.
>>
>> Co-developed-by: Mukesh Kumar Savaliya <quic_msavaliy@quicinc.com>
>> Signed-off-by: Mukesh Kumar Savaliya <quic_msavaliy@quicinc.com>
>> Signed-off-by: Viken Dadhaniya <quic_vdadhani@quicinc.com>
>> ---
>>   .../devicetree/bindings/i2c/qcom,i2c-geni-qcom.yaml   | 11 +++++++++++
>>   1 file changed, 11 insertions(+)
>>
>> diff --git a/Documentation/devicetree/bindings/i2c/qcom,i2c-geni-qcom.yaml b/Documentation/devicetree/bindings/i2c/qcom,i2c-geni-qcom.yaml
>> index 9f66a3bb1f80..a26f34fce1bb 100644
>> --- a/Documentation/devicetree/bindings/i2c/qcom,i2c-geni-qcom.yaml
>> +++ b/Documentation/devicetree/bindings/i2c/qcom,i2c-geni-qcom.yaml
>> @@ -66,6 +66,15 @@ properties:
>>     required-opps:
>>       maxItems: 1
>>   
>> +  qcom,load-firmware:
>> +    type: boolean
>> +    description: Optional property to load SE (serial engine) Firmware from protocol driver.
>> +
>> +  qcom,xfer-mode:
>> +    description: Value 1,2 and 3 represents FIFO, CPU DMA and GSI DMA mode respectively.
>> +    $ref: /schemas/types.yaml#/definitions/uint32
>> +    enum: [1, 2, 3]
>> +
>>   required:
>>     - compatible
>>     - interrupts
>> @@ -142,5 +151,7 @@ examples:
>>           interconnect-names = "qup-core", "qup-config", "qup-memory";
>>           power-domains = <&rpmhpd SC7180_CX>;
>>           required-opps = <&rpmhpd_opp_low_svs>;
>> +        qcom,load-firmware;
> 
> please use instead:
> firmware-name = "qcom/sc7180/qupv3.elf"

Agreed, will be adopted in next patch.

> 
>> +        qcom,xfer-mode = <1>;
>>       };
>>   ...
>> -- 
>> 2.34.1
>>
>