Re: [PATCH 1/8] drm/sun4i: backend: Move line stride setup to buffer setup function

[Neil Armstrong <narmstrong@baylibre.com>]

On 13/12/2017 16:33, Maxime Ripard wrote:
> Setup the line stride in the buffer setup function, since it's tied to the
> buffer itself, and is not needed when we do not set the buffer in the
> backend.
> 
> This is for example the case when using the frontend and then routing its
> output to the backend.
> 
> Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com>
> ---
>  drivers/gpu/drm/sun4i/sun4i_backend.c | 14 +++++++-------
>  1 file changed, 7 insertions(+), 7 deletions(-)
> 
> diff --git a/drivers/gpu/drm/sun4i/sun4i_backend.c b/drivers/gpu/drm/sun4i/sun4i_backend.c
> index 847eecbe4d14..c99d1a7e815a 100644
> --- a/drivers/gpu/drm/sun4i/sun4i_backend.c
> +++ b/drivers/gpu/drm/sun4i/sun4i_backend.c
> @@ -141,7 +141,6 @@ int sun4i_backend_update_layer_coord(struct sun4i_backend *backend,
>  				     int layer, struct drm_plane *plane)
>  {
>  	struct drm_plane_state *state = plane->state;
> -	struct drm_framebuffer *fb = state->fb;
>  
>  	DRM_DEBUG_DRIVER("Updating layer %d\n", layer);
>  
> @@ -153,12 +152,6 @@ int sun4i_backend_update_layer_coord(struct sun4i_backend *backend,
>  						   state->crtc_h));
>  	}
>  
> -	/* Set the line width */
> -	DRM_DEBUG_DRIVER("Layer line width: %d bits\n", fb->pitches[0] * 8);
> -	regmap_write(backend->engine.regs,
> -		     SUN4I_BACKEND_LAYLINEWIDTH_REG(layer),
> -		     fb->pitches[0] * 8);
> -
>  	/* Set height and width */
>  	DRM_DEBUG_DRIVER("Layer size W: %u H: %u\n",
>  			 state->crtc_w, state->crtc_h);
> @@ -218,6 +211,13 @@ int sun4i_backend_update_layer_buffer(struct sun4i_backend *backend,
>  	u32 lo_paddr, hi_paddr;
>  	dma_addr_t paddr;
>  
> +	/* Set the line width */
> +	DRM_DEBUG_DRIVER("Layer line width: %d bits\n", fb->pitches[0] * 8);
> +	regmap_write(backend->engine.regs,
> +		     SUN4I_BACKEND_LAYLINEWIDTH_REG(layer),
> +		     fb->pitches[0] * 8);
> +
> +
>  	/* Get the start of the displayed memory */
>  	paddr = drm_fb_cma_get_gem_addr(fb, state, 0);
>  	DRM_DEBUG_DRIVER("Setting buffer address to %pad\n", &paddr);
> 

Reviewed-by: Neil Armstrong <narmstrong@baylibre.com>