Re: CPU load after killing iwlagn with RF kill switch

["Tomas Winkler" <tomasw@gmail.com>]

On Sun, Aug 17, 2008 at 4:59 AM, Mirco Tischler <mt-ml@gmx.de> wrote:
> On Fri, 15 Aug 2008 23:50:10 +0300, Leonid Podolny wrote:
>> Hi,
>> With a new iwlagn driver and 2.6.27-rc3, if I turn off the wireless
>> (intel 4965ag) by RF kill switch, the CPU utilization of ksoftirqd
>> process raises to 100% and stays there until I rmmod the module.
>> Please let me know what further information I can provide.
>
> Hi
>
> Same on my machine with same chip and same kernel.
> If I use the switch on the side of my laptop to turn off wlan, ksoftirqd eats
> up one core of my cpu til I switch it on again or rmmod the iwlagn module. But
> when I switch it on before the device loses connection and then off a second
> time, I now get a (the) second ksoftirqd process eating up the other core too.
> This only happens if a connection is established, though.
> I'm not sure if this problem existed in 2.6.26 but I doubt it. (Will check if I
> find the time).
>
> My dmesg shows me this:
>
> [48067.257539] iwlagn: Radio Frequency Kill Switch is On:
> [48067.257539] Kill switch must be turned off for wireless networking to work.
> [48071.295154] wlan0: No ProbeResp from current AP 00:c0:a8:e5:e5:a5 - assume
> out of range
> [48072.099173] iwlagn: Error sending REPLY_ADD_STA: enqueue_hcmd failed: -5
> [48072.099260] mac80211-phy1: failed to remove key (0, 00:c0:a8:e5:e5:a5) from
> hardware (-5)
> [48072.206028] iwlagn: Error sending REPLY_ADD_STA: enqueue_hcmd failed: -5
> [48072.206028] mac80211-phy1: failed to remove key (1, ff:ff:ff:ff:ff:ff) from
> hardware (-5)
>
> The probably interesting parts of my config look like that:
>
> CONFIG_IWLWIFI=m
> CONFIG_IWLCORE=m
> CONFIG_IWLWIFI_LEDS=y
> CONFIG_IWLWIFI_RFKILL=y
> # CONFIG_IWLWIFI_DEBUG is not set
> CONFIG_IWLAGN=m
> CONFIG_IWLAGN_SPECTRUM_MEASUREMENT=y
> CONFIG_IWLAGN_LEDS=y
> CONFIG_IWL4965=y
> # CONFIG_IWL5000 is not set
> # CONFIG_IWL3945 is not set
>
> CONFIG_RFKILL=m
> # CONFIG_RFKILL_INPUT is not set
> CONFIG_RFKILL_LEDS=y
> CONFIG_IWLWIFI_RFKILL=y
>
> I can recompile with debug options set if this helps. Just haven't found the
> time.

There is gap in current rfkill implementation that we didn't close
yet.  There were also few patches that were not signed by Intel and
are apparently wrong.
Tomas.


> Thanks
> Mirco
>
> P.S.: added some cc's for iwlwifi and rfkill.
>