mirror of https://lore.kernel.org/lkml/
 help / color / mirror / Atom feed
From: Maxim Levitsky <mlevitsk@redhat.com>
To: Sean Christopherson <seanjc@google.com>,
	Paolo Bonzini <pbonzini@redhat.com>
Cc: Vitaly Kuznetsov <vkuznets@redhat.com>,
	Wanpeng Li <wanpengli@tencent.com>,
	Jim Mattson <jmattson@google.com>, Joerg Roedel <joro@8bytes.org>,
	kvm@vger.kernel.org, linux-kernel@vger.kernel.org,
	syzbot+f1d2136db9c80d4733e8@syzkaller.appspotmail.com
Subject: Re: [PATCH 2/4] KVM: nVMX: Synthesize TRIPLE_FAULT for L2 if emulation is required
Date: Tue, 14 Dec 2021 11:12:32 +0200	[thread overview]
Message-ID: <1c66981541a52e8d7c2b72db2ecd1bcc79c16be6.camel@redhat.com> (raw)
In-Reply-To: <20211207193006.120997-3-seanjc@google.com>

On Tue, 2021-12-07 at 19:30 +0000, Sean Christopherson wrote:
> Synthesize a triple fault if L2 guest state is invalid at the time of
> VM-Enter, which can happen if L1 modifies SMRAM or if userspace stuffs
> guest state via ioctls(), e.g. KVM_SET_SREGS.  KVM should never emulate
> invalid guest state, since from L1's perspective, it's architecturally
> impossible for L2 to have invalid state while L2 is running in hardware.
> E.g. attempts to set CR0 or CR4 to unsupported values will either VM-Exit
> or #GP.
> 
> Modifying vCPU state via RSM+SMRAM and ioctl() are the only paths that
> can trigger this scenario, as nested VM-Enter correctly rejects any
> attempt to enter L2 with invalid state.
> 
> RSM is a straightforward case as (a) KVM follows AMD's SMRAM layout and
> behavior, and (b) Intel's SDM states that loading reserved CR0/CR4 bits
> via RSM results in shutdown, i.e. there is precedent for KVM's behavior.
> Following AMD's SMRAM layout is important as AMD's layout saves/restores
> the descriptor cache information, including CS.RPL and SS.RPL, and also
> defines all the fields relevant to invalid guest state as read-only, i.e.
> so long as the vCPU had valid state before the SMI, which is guaranteed
> for L2, RSM will generate valid state unless SMRAM was modified.  Intel's
> layout saves/restores only the selector, which means that scenarios where
> the selector and cached RPL don't match, e.g. conforming code segments,
> would yield invalid guest state.  Intel CPUs fudge around this issued by
> stuffing SS.RPL and CS.RPL on RSM.  Per Intel's SDM on the "Default
> Treatment of RSM", paraphrasing for brevity:
> 
>   IF internal storage indicates that the [CPU was post-VMXON]
>   THEN
>      enter VMX operation (root or non-root);
>      restore VMX-critical state as defined in Section 34.14.1;
>      set to their fixed values any bits in CR0 and CR4 whose values must
>      be fixed in VMX operation [unless coming from an unrestricted guest];
>      IF RFLAGS.VM = 0 AND (in VMX root operation OR the
>         “unrestricted guest” VM-execution control is 0)
>      THEN
>        CS.RPL := SS.DPL;
>        SS.RPL := SS.DPL;
>      FI;
>      restore current VMCS pointer;
>   FI;
> 
> Note that Intel CPUs also overwrite the fixed CR0/CR4 bits, whereas KVM
> will sythesize TRIPLE_FAULT in this scenario.  KVM's behavior is allowed
> as both Intel and AMD define CR0/CR4 SMRAM fields as read-only, i.e. the
> only way for CR0 and/or CR4 to have illegal values is if they were
> modified by the L1 SMM handler, and Intel's SDM "SMRAM State Save Map"
> section states "modifying these registers will result in unpredictable
> behavior".
> 
> KVM's ioctl() behavior is less straightforward.  Because KVM allows
> ioctls() to be executed in any order, rejecting an ioctl() if it would
> result in invalid L2 guest state is not an option as KVM cannot know if
> a future ioctl() would resolve the invalid state, e.g. KVM_SET_SREGS, or
> drop the vCPU out of L2, e.g. KVM_SET_NESTED_STATE.  Ideally, KVM would
> reject KVM_RUN if L2 contained invalid guest state, but that carries the
> risk of a false positive, e.g. if RSM loaded invalid guest state and KVM
> exited to userspace.  Setting a flag/request to detect such a scenario is
> undesirable because (a) it's extremely unlikely to add value to KVM as a
> whole, and (b) KVM would need to consider ioctl() interactions with such
> a flag, e.g. if userspace migrated the vCPU while the flag were set.
> 
> Cc: stable@vger.kernel.org
> Signed-off-by: Sean Christopherson <seanjc@google.com>
> ---
>  arch/x86/kvm/vmx/vmx.c | 32 ++++++++++++++++++++++++--------
>  1 file changed, 24 insertions(+), 8 deletions(-)
> 
> diff --git a/arch/x86/kvm/vmx/vmx.c b/arch/x86/kvm/vmx/vmx.c
> index 9e415e5a91ab..5307fcee3b3b 100644
> --- a/arch/x86/kvm/vmx/vmx.c
> +++ b/arch/x86/kvm/vmx/vmx.c
> @@ -5900,18 +5900,14 @@ static int __vmx_handle_exit(struct kvm_vcpu *vcpu, fastpath_t exit_fastpath)
>  		vmx_flush_pml_buffer(vcpu);
>  
>  	/*
> -	 * We should never reach this point with a pending nested VM-Enter, and
> -	 * more specifically emulation of L2 due to invalid guest state (see
> -	 * below) should never happen as that means we incorrectly allowed a
> -	 * nested VM-Enter with an invalid vmcs12.
> +	 * KVM should never reach this point with a pending nested VM-Enter.
> +	 * More specifically, short-circuiting VM-Entry to emulate L2 due to
> +	 * invalid guest state should never happen as that means KVM knowingly
> +	 * allowed a nested VM-Enter with an invalid vmcs12.  More below.
>  	 */
>  	if (KVM_BUG_ON(vmx->nested.nested_run_pending, vcpu->kvm))
>  		return -EIO;
>  
> -	/* If guest state is invalid, start emulating */
> -	if (vmx->emulation_required)
> -		return handle_invalid_guest_state(vcpu);
> -
>  	if (is_guest_mode(vcpu)) {
>  		/*
>  		 * PML is never enabled when running L2, bail immediately if a
> @@ -5933,10 +5929,30 @@ static int __vmx_handle_exit(struct kvm_vcpu *vcpu, fastpath_t exit_fastpath)
>  		 */
>  		nested_mark_vmcs12_pages_dirty(vcpu);
>  
> +		/*
> +		 * Synthesize a triple fault if L2 state is invalid.  In normal
> +		 * operation, nested VM-Enter rejects any attempt to enter L2
> +		 * with invalid state.  However, those checks are skipped if
> +		 * state is being stuffed via RSM or KVM_SET_NESTED_STATE.  If
> +		 * L2 state is invalid, it means either L1 modified SMRAM state
> +		 * or userspace provided bad state.  Synthesize TRIPLE_FAULT as
> +		 * doing so is architecturally allowed in the RSM case, and is
> +		 * the least awful solution for the userspace case without
> +		 * risking false positives.
> +		 */
> +		if (vmx->emulation_required) {
> +			nested_vmx_vmexit(vcpu, EXIT_REASON_TRIPLE_FAULT, 0, 0);
> +			return 1;
> +		}
> +
>  		if (nested_vmx_reflect_vmexit(vcpu))
>  			return 1;
>  	}
>  
> +	/* If guest state is invalid, start emulating.  L2 is handled above. */
> +	if (vmx->emulation_required)
> +		return handle_invalid_guest_state(vcpu);
> +
>  	if (exit_reason.failed_vmentry) {
>  		dump_vmcs(vcpu);
>  		vcpu->run->exit_reason = KVM_EXIT_FAIL_ENTRY;



Reviewed-by: Maxim Levitsky <mlevitsk@redhat.com>
Best regards,
	Maxim Levitsky


  reply	other threads:[~2021-12-14  9:12 UTC|newest]

Thread overview: 10+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2021-12-07 19:30 [PATCH 0/4] KVM: VMX: Fix handling of invalid L2 guest state Sean Christopherson
2021-12-07 19:30 ` [PATCH 1/4] KVM: VMX: Always clear vmx->fail on emulation_required Sean Christopherson
2021-12-14  9:12   ` Maxim Levitsky
2021-12-07 19:30 ` [PATCH 2/4] KVM: nVMX: Synthesize TRIPLE_FAULT for L2 if emulation is required Sean Christopherson
2021-12-14  9:12   ` Maxim Levitsky [this message]
2021-12-07 19:30 ` [PATCH 3/4] KVM: VMX: Fix stale docs for kvm-intel.emulate_invalid_guest_state Sean Christopherson
2021-12-14  9:12   ` Maxim Levitsky
2021-12-07 19:30 ` [PATCH 4/4] KVM: selftests: Add test to verify TRIPLE_FAULT on invalid L2 guest state Sean Christopherson
2021-12-14  9:15   ` Maxim Levitsky
2021-12-09 11:26 ` [PATCH 0/4] KVM: VMX: Fix handling of " Paolo Bonzini

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1c66981541a52e8d7c2b72db2ecd1bcc79c16be6.camel@redhat.com \
    --to=mlevitsk@redhat.com \
    --cc=jmattson@google.com \
    --cc=joro@8bytes.org \
    --cc=kvm@vger.kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=pbonzini@redhat.com \
    --cc=seanjc@google.com \
    --cc=syzbot+f1d2136db9c80d4733e8@syzkaller.appspotmail.com \
    --cc=vkuznets@redhat.com \
    --cc=wanpengli@tencent.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox

all inboxes | Powered by JetHome®