From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id ; Sat, 6 Jan 2001 00:05:25 -0500 Received: (majordomo@vger.kernel.org) by vger.kernel.org id ; Sat, 6 Jan 2001 00:05:16 -0500 Received: from cr949225-b.rchrd1.on.wave.home.com ([24.112.58.97]:61444 "HELO enfusion-group.com") by vger.kernel.org with SMTP id ; Sat, 6 Jan 2001 00:05:09 -0500 Date: Sat, 6 Jan 2001 00:05:07 -0500 From: Adrian Chung To: linux-kernel@vger.kernel.org Cc: Andre Hedrick Subject: Re: Promise Ultra66 DMA problems. Message-ID: <20010106000507.A2278@rogue.enfusion-group.com> Mime-Version: 1.0 Content-Type: text/plain; charset=us-ascii Content-Disposition: inline User-Agent: Mutt/1.2.5i In-Reply-To: <20010105170838.A1674@rogue.enfusion-group.com>; from adrian@enfusion-group.com on Fri, Jan 05, 2001 at 05:08:38PM -0500 Organization: enfusion-group Sender: linux-kernel-owner@vger.kernel.org X-Mailing-List: linux-kernel@vger.kernel.org On Fri, Jan 05, 2001 at 05:08:38PM -0500, Adrian Chung wrote: > hde: Maxtor 91024U3, ATA DISK drive > hdf: Maxtor 94098U8, ATA DISK drive > hdg: QUANTUM FIREBALLP LM15, ATA DISK drive > hdh: QUANTUM FIREBALLP LM30, ATA DISK drive I initially added only the two quantum drives to the pdc_quirk_list, and that had no effect, the machine still hung on boot up at the same place. After this, I added the other two Maxtor's as well, and with all four drives in the pdc_quirk_list, the system booted up fine. Should I narrow this down further? Will it be detrimental in any way to have all four drives listed in the quirks table if they needn't be? cat /proc/ide/pdc: PDC20262 Chipset. ---------------------------- General Status --------------------------------- Burst Mode : enabled Host Mode : Normal Bus Clocking : 33 PCI Internal IO pad select : 4 mA Status Polling Period : 0 Interrupt Check Status Polling Delay : 0 ------------ Primary Channel ---------------- Secondary Channel ------------- enabled enabled 66 Clocking enabled enabled Mode PCI Mode PCI FIFO Empty FIFO Empty ------------ drive0 --------- drive1 -------- drive0 ---------- drive1 ------ DMA enabled: yes yes yes yes DMA Mode: UDMA 4 UDMA 4 UDMA 4 UDMA 4 PIO Mode: PIO 4 PIO 4 PIO 4 PIO 4 and hdparm yields about 25Mbit/s. I'm trying to get the runtime system to hang like it did before as well... I'm running "dd if=/dev/hdX of=/dev/null &" on all four drives simultaneously, and about 3 times per drive to hit the controller and disk I/O system really hard. So far, it's all been fine. Hopefully that means that the problems gone away. :) Thanks for the help! -- Adrian - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org Please read the FAQ at http://www.tux.org/lkml/