From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id ; Sat, 23 Jun 2001 21:04:48 -0400 Received: (majordomo@vger.kernel.org) by vger.kernel.org id ; Sat, 23 Jun 2001 21:04:39 -0400 Received: from mail6.speakeasy.net ([216.254.0.206]:44045 "HELO mail6.speakeasy.net") by vger.kernel.org with SMTP id ; Sat, 23 Jun 2001 21:04:25 -0400 Content-Type: text/plain; charset=US-ASCII From: safemode To: linux-kernel@vger.kernel.org Subject: cd writer problems with 2.4.5ac17 Date: Sat, 23 Jun 2001 21:03:22 -0400 X-Mailer: KMail [version 1.2.3] MIME-Version: 1.0 Content-Transfer-Encoding: 7BIT Message-Id: <20010624010433Z262618-17720+7036@vger.kernel.org> Sender: linux-kernel-owner@vger.kernel.org X-Mailing-List: linux-kernel@vger.kernel.org I'm thinking that this is a kernel scsi emu problem rather than a CDR problem due to the past scsi emulation mails i've seen about previous kernels. I've been forced to move to 2.4.x because i want to use my promise ata66 ide controller and the 2.2 promise drivers dont work for it. My CDR is detected as Vendor: CREATIVE Model: CD-RW RW8438E Rev: FC03 by the ide-scsi module. Now the problem is, cdrecord is very tempermental with it and it shouldn't be. Often there are input output errors reading blank media before writing, these lead to drive lockups that can only be recovered by power cycling (rebooting). The cdrecord i'm using is version 1.11a04 and i'm going to try an earlier release to see if it's a cdrecord issue in a bit but i wanted to get responses from anyone else who may be having these problems early if it isn't. Errors: In dmesg this shows up. scsi : aborting command due to timeout : pid 0, scsi0, channel 0, id 0, lun 0 Write (10) 00 00 00 00 00 00 00 1f 00 hde: irq timeout: status=0xd0 { Busy } hde: ATAPI reset complete I cant get the cdrecord actual error until i reboot, but then when i do it's random when the error does occur, just that it does after a few uses of the burner. on a side note. the kernel really likes to hang up when writing to a cd. This never used to happen a few kernel releases ago. it slows everything else down but when the cdr does write a cd, it does so without losing any fifo buffer. Any more info needed i'd like to give to figure this out, the thing is, everytime this happens i have to reboot to use the CDR again. It wont even detect unless it's power cycled and just unplugging the power cord and putting it back in doesn't really help because it causes one of my other drives to flip out. (did that last night.)