From: "Jeff V. Merkey" <jmerkey@vger.timpanogas.org>
To: linux-kernel@vger.kernel.org
Cc: jmerkey@timpanogas.org
Subject: ioremap()/PCI sickness in 2.4.18-rc2
Date: Wed, 20 Feb 2002 10:33:20 -0700 [thread overview]
Message-ID: <20020220103320.A32211@vger.timpanogas.org> (raw)
On 2.4.18-rc2 with the Dolphin SCI adapters installed and running
with 2 GB of physical memory installed in the system, ioremap() fails
to properly map the SCI adapter PREFETCH space. This error does not
occur opn 2.4.18-rc2 when the physical memory installed in the system
is less than 1 GB. This error is proceeded by a failure in the PCI
subsystem to properly allocate resources and reports the following
message in the /var/log/messages file:
Feb 20 09:49:38 lnx1 kernel: PCI: PCI BIOS revision 2.10 entry at 0xfdbb1, last bus=2
Feb 20 09:49:38 lnx1 kernel: PCI: Using configuration type 1
Feb 20 09:49:38 lnx1 kernel: PCI: Probing PCI hardware
Feb 20 09:49:38 lnx1 kernel: PCI: Unable to handle 64-bit address for device 00:05.0
Feb 20 09:49:38 lnx1 kernel: PCI: Unable to handle 64-bit address for device 00:05.1
Feb 20 09:49:38 lnx1 kernel: PCI: Discovered primary peer bus 02 [IRQ]
Feb 20 09:49:38 lnx1 kernel: PCI: Using IRQ router ServerWorks [1166/0200] at 00:0f.0
Feb 20 09:49:38 lnx1 kernel: PCI->APIC IRQ transform: (B0,I2,P0) -> 18
Feb 20 09:49:38 lnx1 kernel: PCI->APIC IRQ transform: (B0,I6,P0) -> 31
Feb 20 09:49:38 lnx1 kernel: PCI->APIC IRQ transform: (B0,I15,P0) -> 10
Feb 20 09:49:38 lnx1 kernel: PCI->APIC IRQ transform: (B1,I0,P0) -> 30
Feb 20 09:49:38 lnx1 kernel: PCI->APIC IRQ transform: (B2,I2,P0) -> 24
=====>
Feb 20 09:49:38 lnx1 kernel: PCI: Cannot allocate resource region 0 of device 00:05.0
Feb 20 09:49:38 lnx1 kernel: PCI: Cannot allocate resource region 0 of device 00:05.1
Feb 20 09:49:38 lnx1 kernel: PCI: Failed to allocate resource 1(0-ffffffff) for 00:05.0
Feb 20 09:49:38 lnx1 kernel: PCI: Failed to allocate resource 1(0-ffffffff) for 00:05.1
This message does not occur on systems running 2.4.18-rc2 if they have
less than 1 GB of physical memory installed. The address ranges being
mapped are as follows, and the SCI adapter reports the attached errors:
Feb 20 09:49:45 lnx1 sci: Reading IRM driver configuration informaiton from /opt/DIS/sbin/../lib/modules/pcisci.conf
Feb 20 09:49:45 lnx1 kernel: SCI Driver : Linux SMP support disabled
Feb 20 09:49:45 lnx1 kernel: SCI Driver : using MTRR
Feb 20 09:49:45 lnx1 kernel: PCI SCI Bridge - device id 0xd667 found
Feb 20 09:49:45 lnx1 kernel: 1 supported PCI-SCI bridges (PSB's) found on the system
Feb 20 09:49:45 lnx1 kernel: Define PSB 1 key: Bus: 2 DevFn: 16
Feb 20 09:49:45 lnx1 kernel: Key 1: Key: (Bus: 2,DevFn: 16), Device No. 1, irq 24
Feb 20 09:49:45 lnx1 kernel: Mapping address space non cacheable CSR space: phaddr febe0000 sz 131072 out of 131072
Feb 20 09:49:45 lnx1 kernel: Mapping address space non cacheable CSR space: vaddr f8914000
Feb 20 09:49:45 lnx1 kernel: Mapping address space non cacheable IO space: phaddr fd000000 sz 16777216 out of 16777216
Feb 20 09:49:45 lnx1 kernel: Mapping address space non cacheable IO space: vaddr f8935000
Feb 20 09:49:45 lnx1 kernel: SCI Adapter 0 : User request to reduce prefetchspace size from 0x20000000 to 0x1c000000
=====>
Feb 20 09:49:45 lnx1 kernel: Mapping address space PREFETCH space: phaddr c0000000 sz 469762048 out of 469762048
Feb 20 09:49:45 lnx1 kernel: Failed to map address space PREFETCH space
Feb 20 09:49:45 lnx1 kernel: SCI Driver : Adapter init failed!!
Feb 20 09:49:45 lnx1 kernel: SCI Driver : init failed!
Feb 20 09:49:45 lnx1 sci: ERROR: IRM Driver failed to load
Feb 20 09:49:45 lnx1 sci: Check /var/log/scilog for details
Feb 20 09:49:45 lnx1 rc: Starting sci: failed
/proc/iomem on the system is reporting the following attached
hardware devices and their address mappings:
00000000-0009f3ff : System RAM
0009f400-0009f7ff : reserved
000a0000-000bffff : Video RAM area
000c0000-000c7fff : Video ROM
000cc000-000ccfff : Extension ROM
000f0000-000fffff : System ROM
00100000-3fffffff : System RAM
00100000-002881d5 : Kernel code
002881d6-00319977 : Kernel data
b1fff000-b1ffffff : ServerWorks CNB20HE Host Bridge
b2000000-b3ffffff : ServerWorks CNB20HE Host Bridge
b4100000-bc1fffff : PCI Bus #01
b8000000-bbffffff : ATI Technologies Inc Rage 128 PF
=========> we are mapping this address range
c0000000-dfffffff : Dolphin Interconnect Solutions AS PSB66 SCI-Adapter D33x
fc400000-fc4fffff : PCI Bus #01
fc4fc000-fc4fffff : ATI Technologies Inc Rage 128 PF
fc900000-fc9fffff : Intel Corp. 82557 [Ethernet Pro 100]
fcac0000-fcadffff : Intel Corp. 82543GC Gigabit Ethernet Controller
fcae0000-fcaeffff : Intel Corp. 82543GC Gigabit Ethernet Controller
fcafe000-fcafefff : Intel Corp. 82557 [Ethernet Pro 100]
fcafe000-fcafefff : eepro100
fcaff000-fcafffff : ServerWorks OSB4/CSB5 OHCI USB Controller
fd000000-fdffffff : Dolphin Interconnect Solutions AS PSB66 SCI-Adapter D33x
febe0000-febfffff : Dolphin Interconnect Solutions AS PSB66 SCI-Adapter D33x
fec00000-fec01fff : reserved
fee00000-fee00fff : reserved
fff80000-ffffffff : reserved
The specific code that is failing is attached. Any ideas as to what
is broken here? Looks like the mapping code is busted if the system
has over 1 GB of physical memory with certain hardware. The window
size we are attempting to map is 512 MB. This works with less than
1 GB of memory and I have attempted 4GB and 64GB compile options and
it does not work.
Jeff
next reply other threads:[~2002-02-20 17:16 UTC|newest]
Thread overview: 26+ messages / expand[flat|nested] mbox.gz Atom feed top
2002-02-20 17:33 Jeff V. Merkey [this message]
2002-02-20 17:35 ` Jeff V. Merkey
2002-02-20 17:26 ` Jeff Garzik
2002-02-20 17:46 ` Jeff V. Merkey
2002-02-20 17:30 ` David S. Miller
2002-02-20 18:00 ` Jeff V. Merkey
2002-02-20 21:54 ` ioremap()/PCI sickness in 2.4.18-rc2 (FIXED ALMOST) Jeff V. Merkey
2002-02-20 21:51 ` Jeff Garzik
2002-02-20 22:20 ` Jeff V. Merkey
2002-02-20 22:53 ` Jeff V. Merkey
2002-02-20 23:06 ` Alan Cox
2002-02-20 23:35 ` Jeff V. Merkey
2002-02-20 23:44 ` Pete Zaitcev
2002-02-20 22:10 ` Jeff V. Merkey
2002-02-20 22:08 ` arjan
2002-02-22 11:08 ` Steffen Persvold
2002-02-22 18:17 ` Jeff V. Merkey
2002-02-22 18:42 ` David Mosberger
2002-02-22 18:51 ` Jeff Garzik
2002-02-22 19:01 ` David Mosberger
2002-02-22 19:42 ` Jeff V. Merkey
2002-02-23 2:22 ` Richard Henderson
2002-02-20 18:44 ` ioremap()/PCI sickness in 2.4.18-rc2 Steffen Persvold
2002-02-20 20:36 ` Jeff V. Merkey
2002-02-22 11:49 ` Steffen Persvold
2002-02-22 18:21 ` Jeff V. Merkey
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20020220103320.A32211@vger.timpanogas.org \
--to=jmerkey@vger.timpanogas.org \
--cc=jmerkey@timpanogas.org \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®