Linux version 2.4.21-pre3-ac3 (chris@cooper.home) (gcc version 3.2.1 20021207 (Gentoo Linux 3.2.1-20021207)) #3 Sun Jan 12 12:43:13 GMT 2003
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 00000000000a0000 (usable)
 BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 0000000008000000 (usable)
 BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
128MB LOWMEM available.
On node 0 totalpages: 32768
zone(0): 4096 pages.
zone(1): 28672 pages.
zone(2): 0 pages.
Kernel command line: root=/dev/hda2 hdc=ide-scsi devfs=mount
ide_setup: hdc=ide-scsi
No local APIC present or hardware disabled
Initializing CPU#0
Detected 501.147 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 999.42 BogoMIPS
Memory: 127056k/131072k available (1381k kernel code, 3632k reserved, 493k data, 96k init, 0k highmem)
Dentry cache hash table entries: 16384 (order: 5, 131072 bytes)
Inode cache hash table entries: 8192 (order: 4, 65536 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer cache hash table entries: 8192 (order: 3, 32768 bytes)
Page-cache hash table entries: 32768 (order: 5, 131072 bytes)
CPU: L1 I Cache: 32K (32 bytes/line), D cache 32K (32 bytes/line)
CPU:     After generic, caps: 008021bf 808029bf 00000000 00000002
CPU:             Common caps: 008021bf 808029bf 00000000 00000002
CPU: AMD-K6(tm) 3D processor stepping 0c
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: AMD K6
PCI: PCI BIOS revision 2.10 entry at 0xfb4b0, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Using IRQ router VIA [1106/0586] at 00:07.0
Activating ISA DMA hang workarounds.
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
PnPBIOS: Found PnP BIOS installation structure at 0xc00fc0d0
PnPBIOS: PnP BIOS version 1.0, entry 0xf0000:0xc0f8, dseg 0xf0000
PnPBIOS: 15 nodes reported by PnP BIOS; 15 recorded by driver
PnPBIOS: PNP0c02: ioport range 0x3f0-0x3f1 has been reserved
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
Journalled Block Device driver loaded
devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
udf: registering filesystem
Detected PS/2 Mouse Port.
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
Real Time Clock Driver v1.10e
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
loop: loaded (max 8 devices)
[drm] Initialized tdfx 1.0.0 20010216 on minor 0
Uniform Multi-Platform E-IDE driver Revision: 7.00beta-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: IDE controller at PCI slot 00:07.1
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
VP_IDE: VIA vt82c586b (rev 47) IDE UDMA33 controller on pci00:07.1
    ide0: BM-DMA at 0xe000-0xe007, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0xe008-0xe00f, BIOS settings: hdc:DMA, hdd:pio
hda: JTS CORPORATION CHAMPION MODEL C1600-1A, ATA DISK drive
hda: DMA disabled
blk: queue c031d6a0, I/O limit 4095Mb (mask 0xffffffff)
hdc: CRW9624, ATAPI CD/DVD-ROM drive
hdc: DMA disabled
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: task_no_data_intr: status=0x51 { DriveReady SeekComplete Error }
hda: task_no_data_intr: error=0x04 { DriveStatusError }
hda: 3153024 sectors (1614 MB) w/512KiB Cache, CHS=782/64/63, DMA
Partition check:
 /dev/ide/host0/bus0/target0/lun0: p1 p2
usb.c: registered new driver hub
uhci.c: USB Universal Host Controller Interface driver v1.1
uhci.c: USB UHCI at I/O 0xe400, IRQ 11
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
usb.c: registered new driver hiddev
usb.c: registered new driver hid
hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik <vojtech@suse.cz>
hid-core.c: USB HID support drivers
mice: PS/2 mouse device common for all mice
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 1024 buckets, 8Kbytes
TCP: Hash tables configured (established 8192 bind 16384)
ip_tables: (C) 2000-2002 Netfilter core team
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
ide: no cache flush required.
ide: no cache flush required.
FAT: bogus logical sector size 0
ide: no cache flush required.
FAT: bogus logical sector size 0
ide: no cache flush required.
ide: no cache flush required.
UDF-fs DEBUG lowlevel.c:65:udf_get_last_session: CDROMMULTISESSION not supported: rc=-22
UDF-fs DEBUG super.c:1421:udf_read_super: Multi-session=0
UDF-fs DEBUG super.c:410:udf_vrs: Starting at sector 16 (2048 byte sectors)
UDF-fs DEBUG super.c:1157:udf_check_valid: Failed to read byte 32768. Assuming open disc. Skipping validity check
UDF-fs DEBUG misc.c:285:udf_read_tagged: location mismatch block 256, tag 2174882582 != 256
UDF-fs DEBUG super.c:1211:udf_load_partition: No Anchor block found
UDF-fs: No partition found (1)
ide: no cache flush required.
reiserfs: checking transaction log (device 03:02) ...
Warning, log replay starting on readonly filesystem
reiserfs: replayed 23 transactions in 8 seconds
Using r5 hash to sort names
ReiserFS version 3.6.25
VFS: Mounted root (reiserfs filesystem) readonly.
Mounted devfs on /dev
Freeing unused kernel memory: 96k freed
Adding Swap: 66492k swap-space (priority -1)
ide: no cache flush required.
8139too Fast Ethernet driver 0.9.26
PCI: Assigned IRQ 10 for device 00:08.0
eth0: RealTek RTL8139 Fast Ethernet at 0xc88d4000, 00:03:ce:88:88:d6, IRQ 10
eth0:  Identified 8139 chip type 'RTL-8139C'
ide: no cache flush required.
eth0: Setting 100mbps full-duplex based on auto-negotiated partner ability 45e1.