On Tue, Sep 09, 2003 at 05:38:53PM -0700, Patrick Mochel wrote: > > A patch against 2.6.0-test5 can be found at > > http://developer.osdl.org/~mochel/patches/test5-pm1/test5-pm1.diff.bz2 > I tried your patch on a Asus L3D, and here are the results: echo -n standby > /sys/power/state ---------------------------------- Works fine, but on resume I get this message: APIC error on CPU0: 00(00) The resume continues and completes, but then it switches to init 0 and halts. So this is what happens: - standby - resume (with the above message) - init 0 (this I have still to understand...) If not for the init 0 part, that's ok. echo -n mem > /sys/power/state ------------------------------ Suspend seems to go well, but on resume the screen stays black, I hear the fan turning up, then nothing else. The machine doesn't respond to pings or sysrq, hard reset required. Removing the ehci module, I get something more strange, the resume seems to go well, but the screen remains turned off (I'm not using framebuffer or X). After some disk activity, the power led goes off. I think it is againg going in init 0 just after resume. Reading logs confirms this idea, it is going in init 0 just after resuming completes. Couldn't try disk suspend for time constraints, perhaps next days... Someone has a clue on why it is switching to init 0 ? Attached you find dmesg and tipical suspend->resume messages -- ---------------------------------------- Daniele Venzano Web: http://digilander.iol.it/webvenza/