From: Marc Heckmann <mh@nadir.org>
To: linux-kernel@vger.kernel.org
Subject: 2.6.7-rc2 0IDE "lost interrupt" messages on K8 board
Date: Wed, 9 Jun 2004 00:58:23 -0400 [thread overview]
Message-ID: <20040609045822.GA21455@nadir.org> (raw)
hi,
I recently put together an x86_64 system using an Asus K8V SE deluxe
board.
The system has 3 disks setup in a raid 5 array: 1 SATA (sata_promise)
and 2 PATA on the via controller (hda + hdc).
Under heavy write IO combined with heavy network IO (100 Mbit, samba
fileserving, large files) I get the following messages with 2.6.7-rc2:
hda: dma_timer_expiry: dma status == 0x24
hda: DMA interrupt recovery
hda: lost interrupt
This system freezes up for a few seconds when this happens.
The hda is an ATA-133 capable disk.
Does anyone know how to fix this? Would passing "ide0=serialize
ide1=serialize" help? Would changing some BIOS settings help?
below is the output of lspci -v. I would really like to get this
solved as it is hindering production. I can also provide dmesg output
if needed. The system uses ACPI+APIC. thanks in advance.
00:00.0 Host bridge: VIA Technologies, Inc. VT8385 [K8T800 AGP] Host Bridge (rev 01)
Subsystem: Asustek Computer, Inc.: Unknown device 80a3
Flags: bus master, 66Mhz, medium devsel, latency 8
Memory at f8000000 (32-bit, prefetchable)
Capabilities: <available only to root>
00:01.0 PCI bridge: VIA Technologies, Inc. VT8237 PCI bridge [K8T800 South] (prog-if 00 [Normal decode])
Flags: bus master, 66Mhz, medium devsel, latency 0
Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
Capabilities: <available only to root>
00:07.0 FireWire (IEEE 1394): VIA Technologies, Inc. IEEE 1394 Host Controller (rev 80) (prog-if 10 [OHCI])
Subsystem: Asustek Computer, Inc.: Unknown device 808a
Flags: bus master, medium devsel, latency 64, IRQ 16
Memory at f6400000 (32-bit, non-prefetchable)
I/O ports at 7000 [size=128]
Capabilities: <available only to root>
00:08.0 RAID bus controller: Promise Technology, Inc. PDC20378 (SATA150 TX) (rev 02)
Subsystem: Asustek Computer, Inc.: Unknown device 80f5
Flags: bus master, 66Mhz, medium devsel, latency 32, IRQ 18
I/O ports at 8000
I/O ports at 7800 [size=16]
I/O ports at 7400 [size=128]
Memory at f6600000 (32-bit, non-prefetchable) [size=4K]
Memory at f6500000 (32-bit, non-prefetchable) [size=128K]
Capabilities: <available only to root>
00:0a.0 Ethernet controller: Marvell Yukon Gigabit Ethernet 10/100/1000Base-T Adapter (rev 13)
Subsystem: Asustek Computer, Inc.: Unknown device 811a
Flags: bus master, 66Mhz, medium devsel, latency 64, IRQ 17
Memory at f6800000 (32-bit, non-prefetchable) [size=f6700000]
I/O ports at 8400 [size=256]
Expansion ROM at 00020000 [disabled]
Capabilities: <available only to root>
00:0c.0 Ethernet controller: 3Com Corporation 3c905B 100BaseTX [Cyclone] (rev 30)
Subsystem: 3Com Corporation 3C905B Fast Etherlink XL 10/100
Flags: bus master, medium devsel, latency 64, IRQ 17
I/O ports at a400 [size=f6b00000]
Memory at f6c00000 (32-bit, non-prefetchable) [size=128]
Expansion ROM at 00020000 [disabled]
Capabilities: <available only to root>
00:0d.0 VGA compatible controller: ATI Technologies Inc 3D Rage I/II 215GT [Mach64 GT] (rev 41) (prog-if 00 [VGA])
Subsystem: ATI Technologies Inc 3D Rage I/II 215GT [Mach64 GT]
Flags: bus master, stepping, medium devsel, latency 64
Memory at f7000000 (32-bit, non-prefetchable) [size=f6e00000]
I/O ports at e000 [size=256]
Memory at f6f00000 (32-bit, non-prefetchable) [size=4K]
Expansion ROM at 00020000 [disabled]
00:0f.0 RAID bus controller: VIA Technologies, Inc. VIA VT6420 SATA RAID Controller (rev 80)
Subsystem: Asustek Computer, Inc. A7V600 motherboard
Flags: bus master, medium devsel, latency 64, IRQ 20
I/O ports at e800
I/O ports at d800 [size=4]
I/O ports at d400 [size=8]
I/O ports at d000 [size=4]
I/O ports at c800 [size=16]
I/O ports at c400 [size=256]
Capabilities: <available only to root>
00:0f.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06) (prog-if 8a [Master SecP PriP])
Subsystem: Asustek Computer, Inc. A7V600 motherboard
Flags: bus master, medium devsel, latency 32, IRQ 20
I/O ports at fc00 [size=16]
Capabilities: <available only to root>
00:10.0 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 81) (prog-if 00 [UHCI])
Subsystem: Asustek Computer, Inc. A7V600 motherboard
Flags: bus master, medium devsel, latency 64, IRQ 21
I/O ports at a800 [size=32]
Capabilities: <available only to root>
00:10.1 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 81) (prog-if 00 [UHCI])
Subsystem: Asustek Computer, Inc. A7V600 motherboard
Flags: bus master, medium devsel, latency 64, IRQ 21
I/O ports at b000 [size=32]
Capabilities: <available only to root>
00:10.2 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 81) (prog-if 00 [UHCI])
Subsystem: Asustek Computer, Inc. A7V600 motherboard
Flags: bus master, medium devsel, latency 64, IRQ 21
I/O ports at b400 [size=32]
Capabilities: <available only to root>
00:10.3 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 81) (prog-if 00 [UHCI])
Subsystem: Asustek Computer, Inc. A7V600 motherboard
Flags: bus master, medium devsel, latency 64, IRQ 21
I/O ports at b800 [size=32]
Capabilities: <available only to root>
00:10.4 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 86) (prog-if 20 [EHCI])
Subsystem: Asustek Computer, Inc. A7V600 motherboard
Flags: bus master, medium devsel, latency 64, IRQ 21
Memory at f6d00000 (32-bit, non-prefetchable)
Capabilities: <available only to root>
00:11.0 ISA bridge: VIA Technologies, Inc. VT8237 ISA bridge [K8T800 South]
Subsystem: Asustek Computer, Inc. A7V600 motherboard
Flags: bus master, stepping, medium devsel, latency 0
Capabilities: <available only to root>
00:11.5 Multimedia audio controller: VIA Technologies, Inc. VT8233/A/8235/8237 AC97 Audio Controller (rev 60)
Subsystem: Asustek Computer, Inc. A7V600 motherboard (ADI AD1980 codec [SoundMAX])
Flags: medium devsel, IRQ 22
I/O ports at c000
Capabilities: <available only to root>
00:18.0 Host bridge: Advanced Micro Devices [AMD] K8 NorthBridge
Flags: fast devsel
Capabilities: <available only to root>
00:18.1 Host bridge: Advanced Micro Devices [AMD] K8 NorthBridge
Flags: fast devsel
00:18.2 Host bridge: Advanced Micro Devices [AMD] K8 NorthBridge
Flags: fast devsel
00:18.3 Host bridge: Advanced Micro Devices [AMD] K8 NorthBridge
Flags: fast devsel
reply other threads:[~2004-06-09 4:59 UTC|newest]
Thread overview: [no followups] expand[flat|nested] mbox.gz Atom feed
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20040609045822.GA21455@nadir.org \
--to=mh@nadir.org \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®